Hobart PW12n-ADV handleiding
Handleiding
Je bekijkt pagina 35 van 116
– 35 –
SYMPTOM POSSIBLE CAUSE
No machine operation.
1. Machine off, turn machine on.
2. Blown fuse or tripped circuit breaker at power supply.
Ware spotted or not
clean.
1. Loss of water pressure due to pump obstruction. Power machine off to drain tank.
Disconnect electrical power supply (both dishwasher and
booster if applicable). Check for obstructions at strainer pans, scrap basket and
pump intake.
2.Incorrectwashand/ornalrinsetemperature.ContactServiceforadjustmentor
repair.
3. Excessive mineral deposits thoughout wash and rinse system. Delime unit as
required.
4. Check wash and rinse arms to ensure there are no obstructions and ensure they
rotate properly.
5. Strainers clogged causing inadequate water supply to pump; clean machine
according to Cleaning section, page 22.
6.Incorrectorinsufcientdetergentand/orrinseaidforwaterconditionorsoilload
or chemical dispenser is not working properly. Contact chemical supplier.
7. Excessive soil; scrap dishes before cycle. Ensure wash tank is drained and
cleaned as required.
8. Improper loading of ware. Do not overload machine.
Inadequate rinse
or rinse water
temperature too low.
1. Excessive mineral deposits throughout wash and rinse system. Delime unit as
required.
2. For non-ventless machines, incoming water temperature to booster below 110°F.
For ventless machines, incoming water temperature to machine below
55°F. Machine will automatically extend wash time until booster heats up.
3. Obstruction in rinse arms. Ensure rinse arms rotate freely.
Leaking valve.
1. If hose connection at valve is leaking, check hose gasket to ensure it is seated
properly and not worn or cut.
2. Malfunctioning solenoid valve (leaking or not closing). Contact Hobart Service.
Low / no wash tank
heat.
1. Malfunctioning tank heater or overtemp tripped. Contact Hobart Service.
2. Ensure heating element is clean and free of excessive lime scale. Delime unit as
required.
Noorslowll.
1. Water supply may be off; ensure hot water supply valve is open.
2.Dirtystraineratllhoseconnectioncausingreducedwaterow.Turnoffhot
watersupply,removellhoseandcleanscreen.Reassemble.
Excessive steam or
water vapor after cycle
is complete –
PW10n-ADV,
PW10n-ADVSW,
PW20n-ADV,
PW12n-ADV and
PW12n-ADVSW
models only.
1. Incoming cold water too warm. Contact Hobart Service for adjustment of
condensing cycle time.
Bekijk gratis de handleiding van Hobart PW12n-ADV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hobart |
| Model | PW12n-ADV |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 27655 MB |
