Hobart PW10N-ADV handleiding
Handleiding
Je bekijkt pagina 23 van 116
– 23 –
DELIME INSTRUCTIONS
Toenteradelimecyclewithoutthenotication,presstheDelimebuttonontheHMI.The
delime button is active even while the machine is shut down.
Manual Delime Process (Models PW10n-BAS and PW20n-BAS)
The machine will prompt the operator when to delime based on a set number of cycles
ran. When prompted, the display will read ‘Delime required. Start Delime Cycle?’ If ready
to delime, press either arrow button to highlight ‘yes’ and press the Enter button. Press
Enter button on ‘no’ to delime the machine later. If ‘yes’ is selected, proceed to Step 3
below. Start process at Step 1 if initiating the manual delime process without the prompt.
1. Press the Delime button.
2. Display will prompt ‘Start Delime Cycle?’. Press either arrow button to highlight ‘yes’
and press the Enter button.
3. Display will prompt ‘Please Clean strainer’. Open the machine door and remove the
scrap basket and strainer pans. Clean the basket and pans in a sink with a mild detergent
and rinse.
4. Replace the strainer pan and scrap basket in the machine.
5. Close the machine door and press the Enter button. The machine will drain. Once the
machine has drained, the display will prompt ‘Please add delime’. Open the machine
door and pour the required amount of delime chemical into the wash tank according
to the chemical suppliers’ recommendation for a 21-gallon (PW10n-BAS) or 34-gallon
(PW20n-BAS) wash tank and close the door.
6. Oncethedoorisclosed,presstheEnterbutton.Thetankwillllwithfreshwater.Once
lled,theunitwillbegina10-minutewashcycle.NOTE: The Enter button will appear
on the display once the door is opened.
7. Afterthe10-minutewashcycle,themachinewilldrainandre-llwithfreshwater.Once
lled,theunitwillbegina1-minutewashcycletoushanyremainingdelimechemical
residue.
8. After the 1-minute wash cycle, the machine will drain and power down.
Auto Delime Process (Models PW10n-ADV, PW10n-ADVSW, PW20n-ADV, PW12n-ADV
and PW12n-ADVSW)
The machine will prompt the operator when to delime based on the water hardness and
machine usage. When prompted, the display will read ‘Delime required. Start Delime
Cycle?’ If ready to delime, press either arrow button to highlight ‘yes’ and press the Enter
button. Press the Enter button on ‘no’ to delime the machine later. If ‘yes’ is selected,
proceed to Step 3 below. Start the process at Step 1 if initiating the auto delime process
without the prompt.
NOTE: The machine will automatically pump delime solution into the dish machine
during the auto delime cycle. Ensure sufcient chemical is present in the bottle
and the standpipe is fully inserted into the bottle.
1. Press the Delime button.
2. Display will prompt ‘Start Delime Cycle?’. Press either arrow button to highlight ‘yes’
and press the Enter button.
Bekijk gratis de handleiding van Hobart PW10N-ADV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hobart |
| Model | PW10N-ADV |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 27655 MB |
