Hobart PW10N-ADV handleiding
Handleiding
Je bekijkt pagina 21 van 116
– 21 –
WARE WASHING
Scrape the ware to remove large particles of food and debris. Never use steel wool on
ware to be loaded into the dishmachine.
Open the door and load the dirty ware into the machine. Do not stack ware one on top of
another, as water must have free access to all sides of each piece of ware. Place smaller
items and utensils in an open-type rack.
Do not allow foreign objects to enter the unit, especially metallic contaminants.
After loading the machine, close the door. Press the CYCLE SELECT button to choose the
appropriate cycle based on the ware type and the amount of food soil on the ware. Refer
to the chart below for cycle selection details.
Throughout the wash cycle, WASH is displayed along with the tank water temperature,
the wash icon and a progress bar. During the rinse cycle, RINSE is displayed along
with the rinse temperature, the rinse icon and a progress bar. When the rinse cycle is
completed, the readout displays the tank water temperature.
On ventless models, CONDENSE is displayed along with a fan icon and a progress bar.
When the display reads CYCLE COMPLETE, open the door and remove the clean ware.
The machine is now ready for another cycle.
This machine is not meant to be opened until a cycle has completed, but if an item must
be added after the wash cycle has started, open the door slowly, until the pump stops.
Wait 10 seconds to allow the wash arms to coast down and to avoid water splashing before
opening the door fully.
Operating temperatures for all models are as follows:
For all –ADV and –ADVSW models only – If excessive amounts of steam or water vapor
exit the machine after the cycle is complete and the door is opened, the incoming cold water
temperature may be too high. Contact Hobart Service to adjust the condense time. Increasing
cycle time will increase water consumption and decrease the racks per hour, but should reduce
the steam and water vapor entering the dish room.
CYCLE DESCRIPTION
2
A 2-minute wash cycle is followed by a 10-second freshwater rinse.
(Advansys models have a 70 second (PW10n/PW12n models) or 90 second
(PW20n models) condensing cycle following the rinse cycle.)
4
A 4-minute wash cycle is followed by a 10-second freshwater rinse.
(Advansys models have a 70 second (PW10n/PW12n models) or 90 second
(PW20n models) condensing cycle following the rinse cycle.)
6
A 6-minute wash cycle is followed by a 10-second freshwater rinse.
(Advansys models have a 70 second (PW10n/PW12n models) or 90 second
(PW20n models) condensing cycle following the rinse cycle.)
All rinse cycles are followed by a 10-second dwell; except for the PW20n-ADV models
which have a 30-second dwell.
Sanitizing Mode
Minimum Wash Tank
Temperature
Minimum Rinse
Temperature
Hot Water 150°F (66°C) 180°F (82°C)
Bekijk gratis de handleiding van Hobart PW10N-ADV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hobart |
| Model | PW10N-ADV |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 27655 MB |
