Hobart LXNR-2 handleiding
Handleiding
Je bekijkt pagina 20 van 32
– 20 –
Do not allow foreign objects to enter the unit, especially metallic contaminants.
Throughout the wash cycle, the tank water temperature is displayed on the front panel display, along with the
word WASH and an icon. During the rinse cycle, the rinse water temperature is displayed, along with the word
RINSE and an icon. When the rinse cycle is completed, the readout displays the tank water temperature.
On LXnR and LXGnR models, a progress bar displays the remaining cycle time during the condense cycle.
When the display reads CYCLE COMPLETED, open the door, remove the clean dishes, slide in another rack,
close the door and press the PLAY button.
This dish machine is not meant to be opened until a cycle has completed, but if a dish must be added after
the wash cycle has started, open the door slowly, until the pump stops. Wait 10 seconds to allow the wash
arms to coast down and to avoid water splashing before opening the door fully.
Operating temperatures for all models are as follows:
Sanitizing Mode
Minimum Wash
Temperature
Minimum Rinse
Temperature
Hot Water 150°F (66°C) 180°F (82°C)
Chemical 120°F (49°C) 120°F (49°C)
For LXnR and LXGnR models only – If excessive amounts of steam or water vapor exit the machine
after the cycle is complete and the door is opened, incoming cold water temperature may be too high.
Contact Hobart Service to adjust the rinse and condense times. Increasing cycle time will increase water
consumption and decrease the racks per hour, but should reduce the steam and water vapor entering the
dish room.
To power the machine down, press the PLAY/POWER button for 5 seconds (until progress bar is complete).
The machine will automatically drain.
For LXnC and LXGnPR models only – If the detergent supply is empty after 3 consecutive cycles,
supply and press ENTER to clear the error and prime the pump. The pump will prime for 20 seconds.
along with error code “Error 075”. Replace the rinse aid supply and press ENTER to clear the error and prime
the pump. The pump will prime for 20 seconds.
along with error code “Error 076”. Replace the sanitizer supply and press ENTER to clear the error and prime
the pump. The pump will prime for 20 seconds.
For LXnH, LXnR and LXGnR models only – If the detergent supply is empty after 3 consecutive cycles,
supply and press ENTER to clear the error and prime the pump. The pump will prime for 20 seconds.
along with error code “Error 075”. Replace the rinse aid supply and press ENTER to clear the error and prime
the pump. The pump will prime for 20 seconds.
Bekijk gratis de handleiding van Hobart LXNR-2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hobart |
| Model | LXNR-2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4923 MB |
