Hobart AM16VL-ADV handleiding
Handleiding
Je bekijkt pagina 36 van 42
– 36 –
Error
No.
Text On Screen Error Description Troubleshooting
018 Wash tank water level is
too high.
Wash tank water level is
above the upper limit.
Press and hold the manual drain button for
5 seconds to drain the unit back to normal
level. Press the ENTER button if displayed
to clear the error. If the ENTER button does
not display, press and hold the power button
for 5 seconds. Machine will drain and power
off. If the error persists, contact Hobart
Service.
019 Tank strainer blocked.
Remove strainer, clean and
put back in place.
Tank strainer pan is
blocked.
Remove, clean and replace strainer pan.
Press the ENTER button to clear the error.
The machine will drain and power down if
the water level is low. If the water level has
returned to normal, the machine will power
off, but not drain. Power machine on to con-
tinue operation.
020 Wash tank pressure sensor
error. Drain and restart
machine.
The wash tank water level
did not increase by the an-
ticipated amount after being
lled by the rinse cycle.
Press the ENTER button to clear the error.
The machine will drain and clear the error.
Ensure tank is clean. If the error persists,
contact Hobart Service.
021 Drain hose is clogged.
Clean drain hose and drain
machine again.
Signicant water remains in
wash tank after drain cycle.
Ensure power to machine is off and wash
water has cooled. Verify standpipe and bot-
tom of wash tank are free of debris. Clean
the drain hose and drain the machine. En-
sure drain hose is not kinked and installed
properly. If error remains on screen, press
and hold the power button for 5 seconds to
clear the error. Machine will drain and power
down.
022 Drain hose is clogged.
Clean drain hose.
During wash cycle, water
level not maintained at
normal level.
Ensure power to machine is off and wash
water has cooled. Verify standpipe and bot-
tom of wash tank are free of debris. Clean
the drain hose and drain the machine. En-
sure drain hose is not kinked and installed
properly. If error remains on screen, press
the ENTER button to clear the error.
023 Fill system timeout, inspect
incoming water line.
The ll valve has been ac-
tive for more than the maxi-
mum allowed ll time, and
the wash tank water level
has not been reached. This
error will only occur if unit is
equipped with rapid ll.
Ensure incoming water supply is turned on
and that ll hose is not kinked. Verify water
pressure is 15-65 psi. Press the ENTER
button to clear the error. If the error persists,
contact Hobart Service.
029 Program interrupted. Close
door.
Door is opened during ma-
chine operation.
Close the door and ensure door is fully
seated. The current operation resumes. If
the error persists, contact Hobart Service.
032 Fill error, inspect incoming
water line.
The booster water level did
not reach the proper level
within the set amount of
time.
Ensure incoming water supply is turned on
and that ll hose is not kinked. Verify water
pressure is 15-65 psi. Press the ENTER
button to clear the error. If the error persists,
contact Hobart Service.
Bekijk gratis de handleiding van Hobart AM16VL-ADV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hobart |
| Model | AM16VL-ADV |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 7974 MB |
