Hobart 6430 handleiding
Handleiding
Je bekijkt pagina 10 van 60
– 10 –
6.5 INSTALLATION
The peeler was inspected before leaving the factory. The carrier assumes full responsibility
for the safe delivery upon acceptance of the shipment. Check for possible shipping damage
immediately after receipt.
If the peeler is found to be damaged, complete the following steps;
1. Carrier must be notied within ve business days of receipt.
2. Carrier’s local terminal must be notied immediately upon discovery (note time, date, and
who was spoken to), and follow up and conrm with written or electronic communication.
3. All original packing materials must be kept for inspection purposes.
4. The peeler cannot have been moved, installed, or modied.
5. Notify Hobart customer care at (800) 333-7447.
This machine MUST be cleaned after installation and before being put into service. Refer to
section 6.2, page 7 for instructions.
PEELER UNIT (FIG. 1)
Remove the peeler from its shipping carton and remove the hopper top. Remove the ll tube and
bracket assembly from the peeler housing and the cloth bag containing the ll tube gasket and
acorn nuts. Do NOT remove the rubber molding on bottom of peeler. Lay the peeler on its side.
Slightly loosen the clamp that attaches the drain hose and pull the drain hose down so that it
extends approximately
7
/8” below the bottom of peeler housing. Tighten the clamp.
On units that will NOT use a peel trap, attach the bottom cover plate using the bolts and washers
supplied with the unit.
6.6 LOCATION
The peeler is not suitable for outdoor installation. The peeler must only be operated
by trained sta and must be installed in a area where the use and maintenance is restricted to
trained personnel.
The peeler must be installed on a horizontal, at surface, which is level to a minimum of 1mm
in a 1 metre side to side and front to back. Select a suitable, at, level surface that can support
the weight of the peeler when full. Refer to Table 1, page 9 for weights and dimensions. In areas
where stability may be an issue, the machine should be secured in position.
Ensure there is sucient space around the peeler for the user to operate the controls. Servicing
may be more dicult because of reduced clearances and you should always check that equipment
specications permit the close proximity of other equipment. Refer to pages 11 and 12 for the
overall dimensions of the peeler and clearance required.
Bekijk gratis de handleiding van Hobart 6430, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hobart |
| Model | 6430 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8849 MB |
