Handleiding
Je bekijkt pagina 47 van 84

BEFORE USE
47
Pg.
65–67
3
Cleaning the inside of the refrigerator.
You may plug in the power cord immediately after installing the refrigerator.
Do not share the wall outlet with any other appliances. (Alternating current 220–240 V, rated 10 A or more)
Plug the power cord.
4
● Wipe with a soft, damp cloth, then finish with a dry cloth.
● Rinse the water supply tank and water filter.
*
Do not wipe off the lubricant applied to the slide door rails or the contact surface of the rails.
* At the beginning, the refrigerator may smell of plastic.
If you are concerned, ensure that the room is well ventilated.
(Smell will gradually disappear)
●
Check that the power plug or the cord is not wedged between the back of the refrigerator and the wall in order to prevent the cord from getting hot.
Cooling inside the refrigerator begins
It may take more than 24 hours to cool well the inside of the refrigerator, depending on conditions such as the
ambient temperature or storage state of foods.
Do not put ice cream, uncooled foods or perishable foods in the refrigerator until the inside has cooled well.
Perform
"Ice Maker Cleaning"
when using the automatic ice making function for the first time.
Ice making will start automatically after the inside of the refrigerator has cooled well.
(When using for the first time,
it may take 24 hours or more to make ice
.)
When the temperature inside the refrigerator is low, cooling may not start for about 10 minutes after plugging in the power plug.
Do not peel off the sticker on the back or remove the plastic parts on the sides of the refrigerator at the bottom.
If you attach a magnet or suction cup to the front of the main body or to a door, it may leave a mark.
If you attach paper to the door surface in a high ambient temperature environment, condensation may
form on the door surface or the paper may absorb moisture.
Rust proofing of the piping may be required.
When installing the refrigerator near a hot spring area, industrial area, or near sewer pipes, etc., the piping may corrode due to the effect of sulfide gas.
Contact your dealer. The warranty does not cover failures due to sulfide gas damage, such as blackening of the piping.
After inserting the power plug into a wall outlet, you will hear noise from the refrigerator. It is preparing for operation.
You may also hear a louder noise from the compressor or fan until the inside is cooled enough.
Note
freezer compartment, vegetable compartment) are cooled alternately.)
(the refrigerator compartment and the other storage compartments (ice compartment,
Pg.
67
Plastic parts (left and right)
Sticker
Opening and closing the doors
Use the handles to open and close the doors.
■
To open the door
Do not open the door by holding the swing partition.
(The door cannot be opened)
■
To close the door
Do not close the door with the swing partition opened.
(The door will not close completely)
Do not apply excessive force by opening the door too strongly or leaning against the open door. The door may break.
Swing partition Handle Swing partition Swing partition
Request
●
●
●
●
●
●
●
●
●
Bekijk gratis de handleiding van Hitachi R-GW670TV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hitachi |
| Model | R-GW670TV |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 15601 MB |