Hitachi PV-XH3M handleiding
Handleiding
Je bekijkt pagina 34 van 38
EN-34
Disposable chopsticks
Disposable chopsticks
Vacuum cleaner air duct
Vacuum cleaner air duct
Other problems
Problem
Suction power becomes
weak or stops during
operation.
Is the remaining battery level low?
[Battery indicator is blinking (about
once times per second)]
Is the exhaust abnormally hot?
Is the battery indicator blinks slowly
(about once per four seconds)?
Is the dust case full of dust and debris?
Is dust and debris stuck in the filters?
Is dust and debris clogging the
vacuum cleaner air duct?
Is dust and debris clogging the
power head or mini power brush?
Did you vacuum fine sand or dust
and debris?
Is the remaining battery level low?
Is the vacuum cleaner being
charged?
Is the room temperature lower
than 5°C or higher than 35°C?
Are you using the vacuum cleaner
in a cold place?
Did you leave the vacuum
cleanerunattended for a long
period oftime without charging it?
Is the battery exhausted?
Is dust and debris stuck in the filters?
Are the filters thoroughly dried after washing?
Are the clean filter and dust case
securely attached?
Is dust and debris clogging the
vacuum cleaner air duct?
The motor is being cooled via air flow, which is normal.
It gets warm due to the flow of electrical current to the control circuit,
which is normal.
When continuously operating in places of high temperature, such as under
direct sunlight or in cars exposed to the sun, the safeguard might operate
and the suction power might become weak to prevent the vacuum cleaner
motor and battery from overheating.
Charge the vacuum cleaner by setting the vacuum
cleaner on the charging station or by connecting
the AC adapter to the vacuum cleaner.
Stop operation by pressing the control
button. Wait for the vacuum cleaner to
cool down, and then start operation again.
Empty the dust case.
Clean the filters (wash with water).
Remove the dust
and debris using
disposable
chopsticks, etc.
Remove the dust and debris.
Empty the dust case and perform maintenance
(wash with water) on the filters.
Charge the battery.
Remove the vacuum cleaner from the charging
station or disconnect the AC adapter.
When using the vacuum cleaner or charging
the battery, make sure the ambient
temperature is between 5°C and 35°C.
Leave the vacuum cleaner in an area where the
ambient temperature is between 5°C and 35°C. Wait
for the vacuum cleaner to warm up, and then try again.
The battery capacity might be temporarily
recovering poorly. Repeat the procedure of
using the cleaner until the battery
isexhausted and charging fully 2 or 3 times.
If the vacuum cleaner stops running after a
short time even though it is fully charged and
the filters are clean (wash with water), you
might need to replace the battery. Please
consult with a Hitachi authorized service agent.
Perform maintenance for (wash
with water) each filter.
After washing with water, thoroughly air dry the filters.
Securely attach them.
Remove the dust
and debris using
disposable
chopsticks, etc.
Suction power becomes
weak or stops during
operation.
(Filter indicator is
blinking.) The operation
sound increased.
The cleaner does not
operate, or stops during
operation
Operating time is short
even after charging
The exhaust or vacuum cleaner
gets warm (during operation)
There are abnormal
sounds coming from
around the dust case.
The exhaust smells
strange.
The vacuum cleaner or
AC adapter gets warm
(during charging).
Things to check Instructions Page
P.EN-12
P.EN-33
P.EN-20-EN-22
P.EN-23-EN-25
EN-27-EN-28
P.EN-29 to
EN-30
P.EN-20 to EN-24
EN-27-EN-28
P.EN-12
P.EN-13
P.EN-13
P.EN-20 to
EN-24
EN-27-EN-28
P.EN-27-
EN-28
P.EN-23 to
EN-25
Bekijk gratis de handleiding van Hitachi PV-XH3M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hitachi |
| Model | PV-XH3M |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 6025 MB |
