Hisense WF5I8043 handleiding
Handleiding
Je bekijkt pagina 42 van 50
Water leakage
Abnormal
sound/noise during
washing
Intense vibrations
during spinning
Foreign objects such as keys, coins or pins may have fallen
into the drum. Stop the appliance and check for foreign
objects in the drum. If noise persists after restarting, please
contact after-sales service.
Laundry may be unevenly distributed in the drum. Pause
the program, unlock the door, and redistribute the laundry.
Check whether the appliance is level and whether all four feet
are firmly seated on the floor.
Check whether the transport screw/rods have been removed.
Transport screw/rods must be removed before using the
appliance.
Check whether all foam supports have been removed from the
bottom of the appliance.
Leak from the water supply hose.
Check the connection between the tap and the water supply
hose connector for leaks. If there is a leak, wrap sealing tape
around the end of the tap or replace the tap. It is recommend-
ed to check the connection between the water supply hose
connector and the inlet valve for tightness. Tighten the
connection to eliminate leaks.
Leak from the drain hose.
For top-drain models, the drain hose clips must not be
removed as this will result in a continuous water discharge.
Leak from the detergent drawer.
The detergent drawer is not closed tightly. Push the handle to
close the detergent drawer tightly.
Leak from the door seal.
Check the door seal for foreign objects and clean if
necessary.
The laundry is not removed promptly from the drum.
After the wash cycle is completed, remove the laundry from
the drum promptly.
The appliance is overloaded.
The drum should not be full of laundry and the door should be
easy to close.
The spinning rate is too high.
Set a suitable spinning rate for the type of laundry.
The appliance is equipped with a balance detection and
correction system. After detecting unbalance caused by heavy laundry
(e.g., bathrobes) and several spinning attempts, the system
automatically reduces the spinning rate or even stops the spinning
process to protect the appliance.
If the laundry is still very wet after spinning, take the laundry
out of the drum, shake it loose, and then select the spinning
program again.
Excessive foam may impair the spinning effect. Make sure to
use an appropriate amount of low-foaming detergent.
Check whether the spinning rate is set to "0" or "No Spin".
Poor spinning effect
Wrinkled laundry
Fault phenomenon Recommended countermeasures
42
Bekijk gratis de handleiding van Hisense WF5I8043, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hisense |
| Model | WF5I8043 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 4237 MB |
