Handleiding
Je bekijkt pagina 11 van 35
11
Connecting the filter inlet line to the
water supplier
The connector and the check valve is
provided as one part. You should use
the new connector incidentally but not
the old one you have.
Screw the adaptor onto a suitable 3/4”
BSP connector water outlet, and use the
spanner to tighten it. Fully insert the
water line into the check valve. Then
insert the clip in the install pack as the
figure shown below.
Note:
After installed the filter, please open
the water valve to flush the filter for
5minutes before use.
The initial dark discoloration of water
is normal.
The water lines must be connected
with the potable water only.
To operate properly, the ice maker
requires a water pressure of 207~689
kPa.
Connect filter outlet line to the fridge
The outlet line of the water filter should
be connected with the inlet line of the
refrigerator by a Two-Way Connector.
The water lines must be fully inserted
into the center of the connector to
prevent water leaking.
Insert the 2 clips in the install pack as
shown in the diagram, and then confirm
that each clip holds the line firmly.
Open the water valve to flush the lines,
and check leakage in the water
connectors. If any leak, please check
that if the lines are fully inserted where
the connector leaked. If not, please
install them again, and make sure that
the lines are fully inserted.
Note:
After connect the filter outlet line with
the refrigerator (as shown in the
diagram below), please dispense
several cups of water to flush the lines
Bekijk gratis de handleiding van Hisense RS9P628GPFE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hisense |
| Model | RS9P628GPFE |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 5912 MB |
