Hilti AG 600-20SE handleiding
Handleiding
Je bekijkt pagina 21 van 80
*2381081*
2381081 English 15
7.2 Grinding
Do not allow the accessory tool to jam and avoid excessive pressure on the product.
7.3 Cutting
▶ When cutting, keep the rate of advance moderate and do not tilt the product or the cut-off wheel to either
side (working position is at approx. 90° to the cutting plane).
For best results when cutting profiles and small rectangular tube, start cutting with the cut-off
wheel at the smallest cross-section.
7.4 Rough grinding
▶ Move the product to and fro while maintaining a 5° to 30° angle of attack and applying moderate pressure.
▶ This will avoid overheating and discoloration of the workpiece and help ensure an even surface finish.
7.5 Switching off
▶ Press the rear section of the on/off switch.
▶ The on/off switch jumps into the off position and the motor stops.
8 Care of the product
DANGER
Electric shock due to breakdown of protective insulation. When working on metal under extreme
conditions, conductive dust may accumulate inside the power tool, thereby adversely affecting the protective
insulation.
▶ Use a stationary dust extraction system when working under extreme conditions.
▶ Clean the air vents frequently.
▶ Connect a portable residual current device (GFCI) with a maximum trip current of 30 mA between the
power tool and the power source.
WARNING
Electrical hazards. Improper repairs to electrical parts may lead to serious injuries.
▶ Electrical parts may be repaired only by trained electrical specialists.
▶ Never operate the product when the air vents are blocked. Clean the air vents carefully using a dry brush.
Do not allow foreign objects to enter the interior of the product.
▶ Keep the product, especially its gripping surfaces, clean and free from oil and grease. Do not use
cleaning agents containing silicone.
▶ Clean the outside of the product at regular intervals using a slightly dampened cloth. Do not use a spray,
steam pressure cleaning equipment or running water for cleaning.
Frequent work on conductive materials (e.g. metal, carbon fiber) may make shorter maintenance
intervals necessary. Take your individual workplace risk assessment into account.
8.1 Checks after care and maintenance work
▶ After carrying out care and maintenance, check that all protective and safety devices are fitted and that
they function faultlessly.
8.2 Cleaning and replacing dust filter
Clean the dust filter at regular intervals.
It is essential to replace the dust filter if damaged.
1. Insert the tip of a screwdriver underneath the release slot of the dust filter and pry the dust filter off.
2. After cleaning, re-install the dust filter.
Bekijk gratis de handleiding van Hilti AG 600-20SE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hilti |
| Model | AG 600-20SE |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8376 MB |
