Handleiding
Je bekijkt pagina 19 van 24
©2021 Hestan Commercial Corporation
19
EN
LEAK TESTING & ADJUSTMENT
(cont.)
Verify ignition at each burner. Igniter will make a clicking sound until the flame lights within 4
seconds, then the clicking will stop. Check flame characteristics at each burner per the descriptions
below. Flames should be stable and not dance or lift off the burner ports. Flame may need to burn
for a few minutes to purge the gas lines of impurities. These appear as intermittent orange tips or
even tiny sparks in the flame. This is normal and the flame will eventually stabilize like those shown
in the image below.
If after a few minutes the flames continue to burn mostly yellow, verify that the burner head is
properly installed on the base, then retest. Use caution when handling the burner heads. They can
be very hot.
Turn down the control knob to the simmer setting to check function.
Check each burner individually, then check they operate satisfactorily with other burners on.
Light blue flame - Natural gas normal flame
Light blue flame with yellow tips - LP gas normal flame
Yellow flame - Needs adjustment
LEAK TESTING GRIDDLE
• Make sure the flex hose leading to the orifice has been tightened.
• Make sure all control valves are in the “OFF” position.
• Apply the soap solution to all fittings, flex hoses, etc.
• Turn the gas supply ON.
• Turn on the power. Set the griddle control knob to 350°F. The igniter will glow continuously and
the solenoid gas valve will open in about 30-40 seconds, igniting the burner.
USE CAUTION - VERY HOT - BURN HAZARDUSE CAUTION - VERY HOT - BURN HAZARD
• CHECK ALL CONNECTIONS WHERE YOU APPLIED THE SOAP SOLUTION! Check ALL
the hoses from end to end. Bending of the hoses may have resulted in small cracks in the hoses
which must be found. Apply the soapy solution liberally to detect any leaks. If hoses are cracked,
you will need to replace them.
• Soap bubbles will appear where a leak is present. If a leak is present, immediately turn off gas
supply, tighten any leaking fittings, turn the gas supply back on, and recheck.
• If you cannot stop a gas leak, turn off the gas supply and call the dealer where you purchased
your appliance.
• DO NOT USE THE APPLIANCE UNTIL ALL CONNECTIONS HAVE BEEN CHECKED AND DO
NOT LEAK!
If leak testing is done successfully, turn off the griddle and allow everything to cool. Then replace
the metal cover removed in step 20, and re-install the griddle plate as well.
If you have a gas oven model, proceed to the next section. Otherwise, skip to the
LABELLABEL
section.
Bekijk gratis de handleiding van Hestan KRG484GD, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hestan |
| Model | KRG484GD |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 13468 MB |