Handleiding
Je bekijkt pagina 15 van 24
©2021 Hestan Commercial Corporation
15
EN
CHANGING ORIFICES - GRIDDLE MODELS ONLY
20. GRIDDLE BURNER
The orifice for the griddle burner is located under the cover below (shown in blue). The
hot surface igniter (shown in orange) is attached to this cover. The wires to the igniter pass
through the cover. Remove 4 screws (shown in red) and swing the cover carefully out of the
way to expose the orifice underneath. Use caution as the igniter is very fragile. The retainer
for the temperature sensing bulb is housed in a raised channel (shown in green), which should
also not be disturbed.
21. The orifice is located as shown here. It
is possible to remove the orifice without
disconnecting the hose. Remove the
locknut (shown here in violet) with a
7/8” wrench. Then remove the orifice
with a 1/2” wrench. If necessary, use
another wrench or locking pliers to
prevent the brass elbow from rotating.
Consult the table on page 21 for
identification of orifice sizes. When
installing the new orifice, it must be
completely screwed in as shown in the
diagram on page 14, so only the head of
the orifice is seen relative to the locknut.
The distance between the bracket and
the brass elbow must not be changed.
Do not re-install the cover yet.
Bekijk gratis de handleiding van Hestan KRG484GD, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hestan |
| Model | KRG484GD |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 13468 MB |