Handleiding
Je bekijkt pagina 13 van 24
©2021 Hestan Commercial Corporation
13
EN
CHANGING ORIFICES - OVEN SECTION (GAS OVEN ONLY)
(cont.)
17. COMPANION (SMALL) OVEN ONLY
The air shutter opening must be recalibrated when
changing orifices. Loosen the lockscrew located
on the side of the burner (red arrow). Adjust the
opening according to the dimensions below, and re-
tighten the lockscrew.
Re-install the brackets for all ovens and re-install the
hoses. Do not re-install the kick plate yet.
16. Install the new orifice slowly to avoid cross-
threading and damaging the threads. Consult the
table on page 21 for identification of orifice sizes.
The orifice will become noticeably harder to turn as
you proceed. Use the same technique as shown in
step 15 on the previous page to prevent the elbow
from rotating. Check to make sure the locknut
is tight against the bracket, and the orifice must
be screwed on until touching or almost touching
the locknut. Re-install the bracket back into the
appliance, and re-attach the hose (if removed).
For the 48” Range, repeat this process for the small
oven burner. Do not re-install the kick plate yet.
18. MAIN OVEN - UPPER BURNER
The orifice for the upper burner of the
main oven cavity is located at the rear
of the appliance. Remove the 4 screws
(shown here in red) and remove the rear
cover (shown in yellow). Set aside.
Bekijk gratis de handleiding van Hestan KRG484GD, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hestan |
| Model | KRG484GD |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 13468 MB |