Hestan KDW24BU handleiding
Handleiding
Je bekijkt pagina 12 van 40
INSTALLATION
(CONT.)
CONNECTING TO A WATER VALVE
Connect the inlet hose to a threaded 3/4” water valve using
the supplied filter. Firmly secure the hose by tightening its
ring nut with your hands; finish by tightening another 1/4
turn using a pair of plumbing pliers.
The dishwasher can be filled with water at a temperature of
less than 140°F [60°C]. If the appliance is filled with hot
water, washing times will be reduced by about 20 minutes,
but efficiency will be slightly impaired.
• Recommended temperature: 120°F [49°C], max 140°F
[60°C].
• Recommended water pressure: 7-130 PSI [0.5 - 9 bar]. If
the pressure is too high, use a pressure reducer.
A rubber hose connected to a sink spray may burst if
installed on the same pipes feeding the dishwasher. If your sink is fitted with this accessory,
remove the hose and plug the hole.
DO NOT CUT THE INLET HOSE.
If the hose is cut, the dishwasher will not work, water will
leak and you may be injured. If the hose is too long, wind it
up neatly and place it behind the appliance. The cable
harness and electrical components must not come into
contact with the hydraulic system and the water inlet and
drain hoses.
When connecting the dishwasher drain hose to the sink make sure that the hose is not bent in
order to prevent cracks or breakages that could damage it.
A
©2019 Hestan Commercial Corporation
10
EN
Bekijk gratis de handleiding van Hestan KDW24BU, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hestan |
| Model | KDW24BU |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 9865 MB |