Handleiding
Je bekijkt pagina 10 van 100
10
GB
ate automatically in cyclically reapeted time intervals (higher
level corresponds to longer time of steam generating). Level 5
means that steam is generate in continous mode. It is recom
-
mended to pre-heat chamber to 120°C before turning steam
generating on.
• During the appliance is operated always chamber’s internal
light is on.
• To turn the appliance off wait until time will counts off or turn
timer knob into off position (0) manually.
Only for model 229590
• Appliance’s door is equipped with special system which pro
-
vide to moving internal glass up or down according to the
needs.
• To move the door glass down (Fig. 3 on page 4), open the
appliance door completely and then, applying sufficient force,
slide the glass down until it locks into place (you will hear a
clicking sound).
CAUTION! In this position of the glass, it is only possible to
close the door if there is no trolley in the chamber - preheating
cycle or semi-automatic cleaning cycle. If the trolley is placed
inside, an audible alarm will activated. DO NOT close the door -
risk of damaging the glass.
• To move the door glass upwards, open the door (even par
-
tially) and press the appropriate lever in the lower part (on
the right side of the door) behind the outer glass. The release
mechanism will engage and the glass will automatically
move to the up position. In this position, the appliance can
operate normally, with the trolley placed inside the chamber -
without the trolley, no operation on the appliance is possible.
NOTE: If you move the glass upwards before using the appli
-
ance, we recommend opening the door completely and press-
ing the lever from the inside (Fig. 4A on page 4). If after using
the appliance, for safety, we recommend partially opening the
door and pressing the lever from the outside of the door, using
protective gloves - not included (Fig. 4B on page 4).
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & main-
tenance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
• Food residues should be regularly cleaned and removed from
the appliance. If the appliance is not cleaned properly, it will
reduce its lifespan and may result in a dangerous condition
during use.
Manual cleaning
• Clean the cooled exterior and interior surface with a cloth or
sponge slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be
-
fore and after use.
• Avoid water contacting the electrical components.
• Never immerse the appliance in water or other liquids.
• Never use aggressive cleaning agents, abrasive sponges, or
cleaning agents containing chlorine. Do not use steel wool,
metallic utensils, or any sharp or pointed objects for clean
-
ing. Do not use petrol or solvents!
• No parts are dishwasher safe.
• Clean fan with appropriate descaling detergents to ensure
creating limescales.
• Remove door gasket and wash it separately with warm soapy
water, then rinse and dry with soft cloth.
Semi-automatic cleaning
• Apply a suitable detergent to the chamber walls, fan covers
and the inner door glass. Leave for about 20 minutes.
• Set the temperature to about 100-120°C and the humidity
level to position 5. Set the time to 15 minutes.
• After the cycle is finished, open the door and wait for the ap
-
pliance to cool down. Rinse with water.
• To dry the chamber, set the cycle to 10 minutes and the tem
-
perature to about 180-200°C (repeat the cycle if necessary).
• After cleaning, leave the door slightly open.
Maintenance
• Check the operation of the appliance regularly to prevent se
-
rious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be car
-
ried out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis
-
connect the appliance from power supply when moving and
hold it at the bottom.
• Special care must be taken when moving or transporting the ma-
chine due to its heavy weight. With at least 2 persons or using a
cart. Move the machine slowly, carefully, and never incline more
than 45°.
Troubleshooting
If the appliance does not function properly, please check the
below table for the solution. If you are still unable to solve the
problem, please contact the supplier/service provider.
Problems Possible cause Possible solution
Appliance does
not work (all
indicators light
off).
Faulty connection to
the power mains.
Check connection to
the power mains.
Lack of voltage. Restore the power
supply voltage.
Safety thermal
protection activated.
Restart thermal
protection.
Cooking cycle
set - appliance
does not work.
Door open. Close the door
properly.
Door sensor
damaged.
Contact with technical
service.
Bekijk gratis de handleiding van Hendi 219935, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hendi |
| Model | 219935 |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 16649 MB |
