Helix AMPLIFY 201 DIRECT handleiding
Handleiding
Je bekijkt pagina 20 van 24
20
Conguration examples
IMPORTANT: The crossover frequencies for the high- and lowpass must be set in the preconnected
DSP / DSP amplier.
In series
Two subwoofers with one voice coil (single voice coil)
or one subwoofer with dual voice coil are connected in
series.
Note: The connection of two voice coils in series will re-
sult in doubling the impedance!
Maximum output power of this conguration:
Two subwoofers with 1 x 2 Ohms correspond to a total
impedance of 4 Ohms: 250 Watts RMS
One subwoofer with 2 x 2 Ohms also corresponds to a
total impedance of 4 Ohms: 250 Watts RMS
Two subwoofers with 1 x 1 Ohm correspond to a total
impedance of 2 Ohms: 450 Watts RMS
One subwoofer with 2 x 1 Ohm also corresponds to a
total impedance of 2 Ohms: 450 Watts RMS
Note: The connection of subwoofers with 4 Ohms in
series results in a low output power of the amplier!
Note: The negative terminal of the rst voice coil has to
be connected to the positive terminal of the second voice
coil by using a speaker wire with the same gauge as the
other speaker.
One subwoofer with
a dual voice coil
Two subwoofers with
a single voice coil
Bekijk gratis de handleiding van Helix AMPLIFY 201 DIRECT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Helix |
| Model | AMPLIFY 201 DIRECT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2483 MB |
