Handleiding
Je bekijkt pagina 12 van 57
www.heinner.com
11
Appliance freezes too much
Temperature is set too cold
Turn the temperature regulation
knob to a warmer setting
temporarily
Unsual noises
The appliance is touching the wall or
other objects.
Move the appliance slightly
A component, e.g. a pipe, on the rear
of the appliance is touching another
part of the
Appliance or the wall
If necessary, carefully bend the
component out of the way.
Heavy build-up of frost on the
door seal.
Door seal is not air-tight
Carefully warm the leaking sections
of the door seal with a hair dyer
(on a cool setting). At the same
time shape the warmed door seal
by hand such that it sits correctly.
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here, refer to the rating
plate.
Replace the lamp
The switch of LED lamp is gravity controlled, when the angle dood-opening is bigger than 30 degree, light will
switch on and switch off when the angle is smaller than 30 degree.
Notice: LED lamp does not work when the door is open. Please be released and check as below steps:
• Firstly, loosen screws on the lamp cover
• Secondly, loosen the screws fixed on the lamp electronics parts
• Thirdly, check the cable terminals of electronic parts and terminals of contacting lines for door lamp
is loosening or not. Please fix them if they are not fixed. Then, check the light is on or not. If the lamp
is switch on please install the lamp cover; if not, please further check the electronic part is intact or
not. If necessary, please replace the electronic part to check the lamp is on or not. If the lamp still
does not work, please contact staff of after-sale service for assistance
• The steps of LED lamp installing: fix the cable terminals of electronic parts and contacting lines in the
door liner; install LED lectronic parts in the door liner and fix on by screws; install lamp cover on the
holder and fix to finish all process.
WARNING! The illuminating lamps must not be replaced by the user! If the illuminating lamps is damaged,
contact the customer helpline for assistance. This warning is only for refrigerators that contain illuminating
lamps.
CUSTOMER CARE AND SERVICE
Always use original spare parts.
When contacting our Authorised Service Centre, ensure that you have the following data available: Model
and Serial Number.
The information can be found on the rating plate. Subject to change without notice.
TECHNICAL DATA
The technical information is situated in the rating plate on the internal side of the appliance and on the
energy label.
Bekijk gratis de handleiding van Heinner HCF-HM246CSE++, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Heinner |
| Model | HCF-HM246CSE++ |
| Categorie | Vriezer |
| Taal | Nederlands |
| Grootte | 11515 MB |
