Heinner HBH-M402IEGBK handleiding

65 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 6 van 65
www.heinner.com
5
Do not use a silicon sealant to seal the appliance against the aperture.
This will make it difficult to remove the appliance from the aperture in future, particularly if it needs to
be serviced.
1. Place the bracket (B) over the holes that match the size of the screws. There are one set of screw holes
in each corner of the hob (H). Slightly tighten a screw (C) through the bracket (B) so that the bracket is
attached to the hob, but so that you can still adjust the position.
2. Carefully turn the hob back over and then gently lower it into the aperture hole that you have cut out.
3. On the underneath of the hob, adjust the brackets into a position that is suitable for your worktop.
Then fully tighten the screws (C) to secure the hob into position.
GAS CONNECTION
This appliance must be installed and connected in accordance with installation regulations in force in the
country in which the appliance is to be used.
This appliance is supplied to run on LPG and natural gas. Conversion for use on LPG and natural gases must
only be undertaken by a qualified person.
Installation of appliance
Note: Wear protective gloves to fit the hob.
lf necessary to adjust or install the elbow, it is allowed only torque wrench with 9±1N.m, and work on the
Black nut of manifold instead of on the elbow

Bekijk gratis de handleiding van Heinner HBH-M402IEGBK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkHeinner
ModelHBH-M402IEGBK
CategorieFornuis
TaalNederlands
Grootte13479 MB