Hazet 2588-1/4 handleiding
Handleiding
Je bekijkt pagina 8 van 16
HAZET-WERK
4/4
2588-1/4
HAZET-WERK Güldenwerther Bahnhofstraße 25-29
D-42857 Remscheid • Germany
Tel: +49(0) 21 91 / 7 92-0 • Fax: +49(0) 21 91 / 7 92-200
Email: info@hazet.de Website: www.hazet.com
Install the camshaft sprocket and timing chain.
Loosely fit the camshaft sprocket retaining bolt, ensuring that the
camshaft sprocket rotates freely on the camshaft and that the timing
chain is correctly fitted on to the camshaft and crankshaft sprockets.
Remove slack from the non-tensioned side of the timing chain by
rotating the camshaft sprocket by hand in an anti-clockwise direction,
and then tighten the camshaft retaining bolt.
Refit the timing chain tensioner and tighten to a torque of 60Nm.
Using a suitable counter hold (such as HAZET 2540-2 Camshaft
Holding Tool) remove the camshaft sprocket retaining bolt.
Fit a new bolt, tightening to 50Nm.
Remove the timing tools and rotate the crankshaft two full revolutions
in the direction of engine rotation, stopping just before its timed
position.
Refit HAZET 2588-21 crankshaft locking pin and carefully rotate the
crankshaft pulley in the direction of engine rotation until the web of the
crankshaft contacts the locking pin.
Refitting Timing Cover
When refitting the timing chain cover the correct procedure must be
followed to prevent damage to engine components and to ensure that
a good oil seal is achieved, HAZET 2588-22 timing cover guide pins
form part of this process.
Screw HAZET 2588-22 timing cover guide pins into two of the
threaded holes on the cylinder head, (see picture 11).
Apply a continuous bead of sealant to the inner edge of the timing
cover.
Ensuring that timing cover remains square to the engine, position the
cover over HAZET 2588-22 timing cover guide pins and slide it along
the pins to its fitted position.
Remove HAZET 2588-22 timing cover guide pins.
Fit the timing cover retaining screws, finger tight only at this stage.
Tighten screws in order A, B, C, D, E to 5Nm.
Tighten screws in order A, B, C, D, E, F, G to their final setting of
8Nm.
Install HAZET 2588-20 camshaft locking tool and secure in place with
a suitable bolt.
NOTE: If it is not possible to correctly install HAZET 2588-20
camshaft locking tool then the engine timing requires adjustment.
Using a suitable counter hold (such as HAZET 2540-2 Camshaft
Holding Tool) tighten the camshaft sprocket bolt to its final setting of
50Nm +90 degrees.
When correct valve timing has been established, refer to section
“Refitting timing cover” on page 4 for important information on the
correct assembly procedure.
bk
bl
C
A
B
E
G
F
D
bm
Bekijk gratis de handleiding van Hazet 2588-1/4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hazet |
| Model | 2588-1/4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11300 MB |
