Handleiding
Je bekijkt pagina 49 van 73
Page EN-12 Connection to the power supply – notes for the installer
Connection to the power supply – notes for the installer
WARNING
Risk of electric shock / fire hazard!
Improperly installed electrical connections
can cause electrical shocks and/or short
circuits.
n
Connection to the mains supply may
be made only by an authorised electri-
cian approved by the local energy
supply company, e.g. our Service
Centre. Only then will you benefit from
our warranty and a sufficient level of
safety.
n
Since all poles of the appliance cannot
be disconnected from the mains via an
accessible disconnecting device, an
all-pole disconnecting device in ac-
cordance with overvoltage category III
must be connected within the house
installation with at least 3 mm contact
clearance.
Connection requirements
– The rated voltages allowed as well as
the rating of the device can be found in
the Chapter ‘Technical specifications’.
– Depending on the type of connection al-
lowed, you must
– select the cross-section cable
– the contact bridges are inserted or re-
moved (see tables and diagrams).
– The mains cord used must comply with
the requirements of DIN EN 60335-1
(e.g. H05RR-F model).
– A separate power supply is required.
– When connecting the appliance, VDE
requirements and the ‘Technical con-
nection requirements’ must be ob-
served.
Contact protection must be guaranteed.
Connecting to the mains
The terminal block and connection dia-
grams can be found on the rear side of the
oven.
1. Before accessing the terminals, switch
off all supply circuits and secure them
against being switched on again.
2. Make sure that all poles of the connec-
tion cables are disconnected and that ef-
fective earthing is possible.
3. Connect the leads and, if necessary, the
enclosed brass bridges to the corres-
ponding contact terminals of the cooker
power connection in accordance with
the circuit diagrams shown here.
4. Lay the connection cable behind the
stove so that it does not touch the rear
wall of the cooker. The rear cooker wall
becomes hot while it is in use.
Smallest conductor cross-section
Rated current of
the device in A
Nominal cross sec-
tion in mm
2
> 3 and ≤ 6 0.75
> 6 and ≤ 10 1.0
> 10 and ≤ 16 1.5
> 16 and ≤ 25 2.5
> 25 and ≤ 32 4
> 32 and ≤ 40 6
> 40 and ≤ 63 10
The rated current varies depending on the
connection variant. Accordingly, the min-
imum cross-section shall be selected.
L1 – L3: Phase(s), N: Neutral conductor,
PE: Protective conductor (earth wire)
Bekijk gratis de handleiding van Hanseatic HBCO707A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hanseatic |
| Model | HBCO707A |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 8072 MB |
