Hanover HSD0411 handleiding
Handleiding
Je bekijkt pagina 8 van 10

Reset Operaon: 1. When the height of the device is incorrect or an error code appears, the
device needs to be reset and corrected. Press and hold the buon”3” and buon”4”
simultaneously for 3 seconds to enter this funcon.
2. Aer entering the reset funcon, the display shows “RST”, press and hold the “▼” buon to
reset the device. When the desktop descends to the lowest height, it will bounce upward
and run unl it is displayed “bot”, that is, the reset is completed.
Adjust the An-Collision Sensivity: 1. Press and hold the ” ▲”buon and ” ▼”buon
simultaneously for 3 seconds to switch the sensivity. Switch 1 gear for every operaon, there
are 4 gear range, A-0, A-1, A-2,A-3.
2. When the display shows “A-0”, the desk turns off the an-collision funcon; “A-3” for high
sensivity; “A-2” for middle sensivity; “A-1” for low sensivity. (Factory default A-0)
3. When the desk rises or descends, it will rebound immediately when it encounters an
obstacle to protect.
Troubleshoong:
1. Reset: When the LED shows" " or " ", press and hold “▼”buon to reset the desk,
when the desktop descends to the lowest height, it will bounce upward and run unl the LED
shows “bot”, that is, the reset is completed.
2. When it does't work and the LED shows "E01" or "E02", please retry 18 mins later.
3. If the “▼” buon does't work, and the LED shows other code, please check the cable connecon
and then cut off thepower for at least 10 seconds. Reconnect to the power and press “▼” buon to
start the reset process when it shows the " " or " " .
4. If all these above process are inefficient, plz contact our customer service.
Bekijk gratis de handleiding van Hanover HSD0411, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hanover |
| Model | HSD0411 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1077 MB |
