Hama 176651 handleiding
Handleiding
Je bekijkt pagina 8 van 26
7
The following steps are required to commission the device:
• Connect the device to a properly installed and easily accessible mains socket.
• Put the device in pairing mode by holding the button for around 5 seconds. The LED starts to ash
quickly.
• You can secure the camera into place using the adhesive pads or mounting kit supplied.
• Be aware that the intended mounting surface must be free from dust and grease. Use a suitable
cleaner from a specialist retailer for this.
• Be aware that the adhesive pads are intended to be permanent. Carefully pull the adhesive pad off
the mounting surface to remove it.
• Various environmental inuences, such as moisture in the air, sunlight, cold, etc., can impair the
long-term stickiness of the adhesive pads.
• Possible residue on the mounting surface after removal of the adhesive pads cannot be ruled out!
• Do not mount the product above locations where persons might sit or stand.
• Before mounting, check that the wall you have chosen is suitable for the weight to be mounted.
Also make sure that there are no electric, water, gas or other lines running through the wall at the
mounting site.
Bekijk gratis de handleiding van Hama 176651, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hama |
| Model | 176651 |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 2091 MB |
