Haier HWD150-BP14986ES8U1 handleiding
Handleiding
Je bekijkt pagina 28 van 36
9-Troubleshooting
EN
28
Note: Foam formation
If too much foam is inspected during spin cycle, motor stops and drain pump will be activated
for 90 seconds. If that elimination of foam fails up to 3 times, programme ends without spinning.
Note: Unlock the door
When the washing machine in a safe state (under the water level below the window
along a certain distance, barrel temperature below 55 °C, the inner barrel did not turn),
may unlock the doors of the machine operation.
Problem Cause Solution
Excessive foam fl oats
drum and/or deter-
gent drawer.
• Detergent is not a appropriate.
• Excessive use of detergent.
• Check detergent recommen-
dations.
• Reduce amount of detergent.
Automatic adjust-
ment of washing time.
• Washing programme duration will
be adjusted.
• This is normal and doesn‘t af-
fect functionality.
Spinning fails. • Unbalance of laundry. • Check machine load and laundry and
run a spinning programme again.
Unsatisfactory wash-
ing result.
• Degree of pollution does not agree
with selected programme.
• Detergent quantitiy was not suf-
fi cient.
• Maximum load has been exceeded.
• Laundry was unevenly distributed
in the drum.
• Select an other programme.
• Choose the detergent acc. to
the degree of pollution and acc.
to manufaturer specifi cations.
• Reduce loading.
• Loose the laundry.
Washing powder
residues are on the
laundry.
• Insoluble particles of detergent can
remain as white spots on the laun-
dry.
• Perform extra rinse.
• Try to brush the points from
the dry laundry.
• Choose an other detergent.
• Caused by fats such as oils, creams
or ointments.
• Pretreat the laundry with a
special cleaner.
Should the error messages reappear even after the taken measures, switch off the appli-
ance, disconnect the power supply and contact the customer service.
9.4 In case of power failure
The current programme and its setting will be saved.
When power supply is restored operation will be resumed.
In case of power failure during programme running door
opening is mechanically blocked. If the laundry is to
be removed, the water level must not be visible in the
glass door. - Danger of scalding!
▶ Lower the water level according to the chapter
“Care and cleaning-Pump filter”.
▶ Pull lever (A) beneath service fl ap (Fig. 9-1) until
door is unlocked.
▶ Fix all parts and close the service fl ap.
Laundry has grey
patches.
9-1
Bekijk gratis de handleiding van Haier HWD150-BP14986ES8U1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Haier |
| Model | HWD150-BP14986ES8U1 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 4400 MB |
