Handleiding
Je bekijkt pagina 5 van 24
49-5000489 Rev. 7 5
ENGLISH
Remote Control Features And Settings
Remote Control
1. POWER Button
Press the POWER button on the remote control to start or stop
the unit.
2. HEAT Button
In HEAT mode, warm air will blow out after a short period of
time due to the cold-air prevention function. When FAN is set to
AUTO mode, the heat pump automatically adjusts the fan speed
according to room temperature. The will be displayed during
HEAT mode.
3. COOL Button
In COOL mode, the heat pump will blow cool air. When FAN is
set to AUTO, the heat pump automatically adjusts the fan speed
according to the room temperature. The
will be displayed
during COOL mode.
4. DRY Button
DRY mode is used for dehumidification. In DRY mode, when room
temperature becomes lower than setting temperature +2°F, the
Heat Pump will run intermittently at LOW speed regardless of FAN
setting. The crossed out water droplet will be displayed during
DRY mode.
5. SPEED Button
With each press of the SPEED button, the fan speed changes
as follows: LOW-MID-HI-AUTO. The remote control display will
show the fan icon. Hold the SPEED button for 10 seconds to go
into FAN mode. Press any other button to exit this function.
6. TURBO Button
The TURBO function is used for speeding up the air flow to
highest speed in heating and cooling mode. The user interface will
display the "TURBO" icon. Pressing the TURBO again or SPEED
button will exit the Turbo function.
7. QUIET Button
The QUIET function is used for lowing the fan speed to the
lowest speed. The control will display the QUIET icon on the user
interface. Pressing the QUIET button again or the SPEED button
will exit the QUIET function.
8. TEMP +/- Button
TEMP + : The setting temperature will increase 1°F (0.5°C) when
pressed. TEMP - : The setting temperature will decrease 1°F
(0.5°C) when pressed. The range of operating temperature is
60°F-86°F (16°C-30°C).
9. MOTION SENSOR
Press the MOTION SENSE button to activate Motion Sense mode.
Eco will be displayed on the screen. If after 20 minutes no person
is detected in the room, the unit will enter the Eco mode. In this
mode the unit will decrease the temperature set point 1°F (0.5°C)
every 10 minutes in heat mode until it reaches 68°F (20°C) or
increase the temperature set point 1°F (0.5°C) every 10 minutes in
cooling mode until it reaches 78°F (26°C) or above. Accumulated
increase or decrease will not exceed 4°F (2° C). If motion sensor
detects motion in the room, it will exit the Eco mode and change
the temperature or the original setpoint immediately. If the set
temperature is below 68°F (20°C) while in heating mode or 78°F
(26°C) while in cooling mode, this function will not be able to
change temperature further.
Display
circulated
LOW MED HI AUTO
11
13
15
17
19
20
21
10
12
14
16
18
1
2
3
5
7
6
4
8
9
3
4
8
Bekijk gratis de handleiding van Haier AW12EH2HEB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Haier |
| Model | AW12EH2HEB |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 3750 MB |
