Gys flash 107.24 CNT FV handleiding
Handleiding
Je bekijkt pagina 20 van 104
20
User manual
GYSFLASH 107.24 CNT FV
Translation of the original
instructions
LFP Lithium charging curve:
U
I
1 2 3 4 5 6 7
Analysis UVP Wake up Recovery Charge Test Supplement
Equalization /
Balancing
0%
8
Absorption
Maintenance/
Floating charge
9
Equalizing Battery System
2% 85% 95% 99% 100%
Step 1 : Analysis
Analyses the state of the battery (charge level, polarity inversion,
wrong battery…)
Step 6 : Test
Charge conservation test.
Step 2: UVP Wake up
Reactivates batteries in UVP protection (Under Voltage Protection)
Step 7 : Supplement
Reduce current charge to reach 100% charge level.
Step 3: Recovery
Recovery algorithm following a deep discharge.
Step 8: Equalization / Balancing
Balancing the battery cells
Step 4 : Charge
Maximum current fast charge to reach an 90% charge level.
Step 9: Maintenance/Floating charge
Maintain the battery charge level at its maximum.
Step 5: Absorption
Constant voltage charge to reach a 95% charge level.
POWER SUPPLY MODES: SHOWROOM / DIAG+
2
4
3
1
5
Supply
14.2
V
12 V
SHOWROOM
120
Ah
1- Mode
2- Cycle Supply
3- Nominal voltage (mode permitting)
4- Supply voltage
5- Supply current
• Starting the power supply:
1
Manual start
To start the supply mode, press the START/STOP button.
3
5
6
2
1
4
EPS
14.2
V
113
A
01:27:35 105.8
Ah
1- Cycle Supply applied
2- Battery voltage
3- Current delivered by the Gysash
4- Elapsed time
5- Amp-hours delivered
6- Charge cycle progress (if the
inte-
grated charge function is active)
Automatic start-up
If the AUTO-DETECT function is active, power supply will
start automatically after 3 seconds if a battery or contact is
present on the Gysash output (e.g.: vehicle without battery).
Auto - Detect
2.
5
v
Supply
2
During supply mode, the Gysash indicates the voltage, current, elapsed
time and ampere-hours delivered.
3 Press the START/STOP button to stop the charge.
Precautions :
When starting the mode, a current displayed above 10 A means that your battery is discharged. The device will start charging auto-
matically Check that there is no electrical consumer on the vehicle. Wait until the current supplied drops below 10 A before starting
any action on the vehicle (use of the vehicle’s electrical accessories, diagnostic operation, etc.).
Bekijk gratis de handleiding van Gys flash 107.24 CNT FV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Gys |
| Model | flash 107.24 CNT FV |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15482 MB |
