Grunkel I-DancerTurboLaser handleiding
Handleiding
Je bekijkt pagina 39 van 60
This device operates through radio frequency emissions. If not installed properly, it may
cause interference to radio frequency communications.
However, there is no guarantee that interference will not occur in a particular installation.
In the event of interference to radio or television signal reception, you may try to carry out
the following measures:
- Reorient the antenna.
- Increase the space between the robot and the receiver.
- Connect the robot to an outlet on a dierent circuit from the receiver.
- Consult your local Technical Service Center for technical assistance.
CAUTION: Do not make any changes or modications to the robot. Do not attempt to open
it, disassemble it or tamper with its components. Failure to do so will invalidate the war-
ranty.
EN
34
Please place the water tank in the
water tank before starting
When the water tank is removed, cleaning stops. Put the water tank
the water tank back into the robot.
Please place the robot on a surface to
surface to start.
Place the robot on the oor to start cleaning.
Please exit the restricted area
before activating
Move the robot to an unrestricted area to begin.
Place the roboto on a at surface
at surface before starting.
The robot is tilted. Place the robot on a at surface on the oor.
The robot is obstructed. Check for entanglements or obstructions. Clear the oor area
where the robot is operating.
Positioning failure, mapping
mapping again
Mapping data has been lost. The cleanup route is planned again.
cleaning
The robot is stuck. Move the robot to a dierent area and start over.
Check the wheels. Clean and check that there are no objects blocking the wheels.
Check the rotating brush. Clean and check that there are no objects blocking the rotating brush.
Check the side brush. Clean and check that there are no objects blocking the side brush.
Suspended robot, place back on the
on the oor.
The robot is suspended. Move the robot back to the ground.
Please clean the front anti-collision
sensor
Check and clean the front anti-collision sensor..
Please check the sensor on the
right side
Check and clean the right side sensor.
Please check the bumper. Check and clean the bumper.
ERROR MESSAGE POSSIBLE SOLUTION
Bekijk gratis de handleiding van Grunkel I-DancerTurboLaser, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Grunkel |
| Model | I-DancerTurboLaser |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6138 MB |
