Growatt MID 10-30KTL3-XH handleiding
Handleiding
Je bekijkt pagina 8 van 55
3
4
1.1.3.3 Using a ladder
Ÿ Any work which is performed 2 meters or more is known as work at
heights. Use a ladder when working at heights. If on-site
conditions permit, use a double-hook safety belt when climbing the
ladder to prevent falls. Do not attach the hooks to the ladder rung;
instead, attach them to a solid structure that the ladder leans
against. If the safety belt is not available, you are supposed to use
a safety rope for fall protection.
Ÿ The ladder base should be in good condition. Place the ladder on a
level and solid working surface to prevent slipping and tilting.
Ÿ When working at heights, use a platform ladder with guard rails
rather than a straight ladder.
Ÿ When you need to perform live working at heights, use a wooden
or insulated ladder. Check whether the ladder is as per the
standards before using it. Do not use a ladder with potential safety
hazards.
1.1.3.4 Hoisting the equipment
Ÿ When hoisting the equipment, observe local hoisting standards
closely.
WARNING
1.1.3.5 Drilling holes
Ÿ Avoid drilling holes into the water pipes and power cables to
prevent short circuits or other hazards.
Ÿ When drilling holes, protect the equipment from shavings. Remove
shavings from holes in time.
Ÿ When drilling holes, wear protective gears, such as goggles,
masks, and protective gloves.
Ÿ After drilling, clean up any dust inside the hole.
1.1.3.6 Connecting cables
Ÿ You are recommended to prepare firefighting equipment on site,
such as fire sand and fire extinguishers.
Ÿ Wear insulated gloves and use insulated tools to prevent electric
shock injuries.
Ÿ When exposed to light, the PV modules generate high DC voltage
which is present in the DC cables. Ensure that the DC SWITCH on
the inverter is set to OFF before connecting cables.
Ÿ Follow the wiring instructions specified in the user manual;
otherwise, any device damage caused by improper wiring will not
be covered under any warranty.
Ÿ Wear insulated gloves to prevent static electricity from damaging
the components of the inverter.
Ÿ Unqualified persons shall not perform any electrical connections.
Ÿ Do not use aluminum wire as the output cable.
Ÿ Avoid overstress on the cable, which could lead to poor contact.
Ÿ Do not use single-strand wire as the output wire for the inverter.
Ÿ When assembling cables, please keep a distance from the inverter
to prevent cable debris from falling into the inverter, which might
cause short circuits.
Ÿ Damage caused by dust or moisture penetration due to improper
installation of waterproof connectors is beyond the scope of
warranty.
WARNING
NOTICE
WARNING
NOTICE
DANGER
NOTICE
Bekijk gratis de handleiding van Growatt MID 10-30KTL3-XH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Growatt |
| Model | MID 10-30KTL3-XH |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11746 MB |
