Growatt MID 10-30KTL3-XH handleiding
Handleiding
Je bekijkt pagina 7 van 55
1 Safety
1.1 Safety precautions
1.1.1 For operation personnel
1
2
Ÿ Read this entire document before installing, operating and
maintaining the product. Follow the instructions in this manual,
note the safety symbols and observe all safety precautions.
Growatt shall not be held liable for any damage caused by the following circumstances:
Ÿ Damage caused by negligence of the customer or a third party, intentional breach,
gross negligence and improper operations or damage not caused by Growatt.
Ÿ Unauthorized modifications to the product or the software code or disassembly of the
product.
Ÿ Use the product beyond the conditions specified in this manual or failure to meet the
installation/environment requirements in accordance with applicable local and
international standards.
Ÿ Device damage owing to force majeure, such as earthquakes, floods, volcanic
eruptions, debris flows and lightning strikes.
Ÿ Tools and materials prepared by the customer do not comply with local legislation and
relevant standards.
Ÿ Failure to follow the operational instructions and safety warnings provided in the
documentation.
Ÿ Only qualified technicians who have received professional training are permitted to
install and operate the inverter. Installation personnel should read through this
manual prior to installing the instrument.
Ÿ Non-professionals are not allowed to operate the equipment. Do not attempt to
repair, modify or disassemble the inverter by yourself.
Ÿ Do not connect or disconnect power cables when the system is in
operation as it may generate electric arcs and cause damage to
the device.
Ÿ Do not work with power on; otherwise, it might lead to personal
injury.
Ÿ Do not wear conductive objects such as watches, bracelets,
bangles, or rings during operation to avoid an electric shock.
Ÿ Before performing routine maintenance, power off the system and
wait 5 minutes for the capacitor to discharge to a safe level and to
avoid body burns caused by the remaining heat.
Ÿ Insulated tools must be used for all work on the system to avoid
electric shocks. The dielectric withstanding voltage level must
comply with local laws, regulations, standards and specifications.
Ÿ Wear helmets, goggles, insulated gloves, reflective clothes and
safety shoes during operation.
Ÿ If a fault persists after restarting the system, please contact
Growatt support. Tampering with or opening the inverter without
authorization will void the warranty.
DANGER
WARNING
Ÿ Check the equipment for damage before starting installation.
Ÿ During installation, do not open the inverter without permission to
prevent foreign objects from entering the device, which might
cause short circuits.
Ÿ The inverter must be properly grounded.
Ÿ The air inlet and outlet of the fan must not be obstructed.
1.1.3 For equipment installation
Ÿ If multiple persons are required to move the heavy equipment,
consider factors like height when determining the manpower and
work division. Ensure that the weight is evenly distributed to
maintain balance.
Ÿ When moving the equipment manually, wear protective gears such
as gloves, safety shoes and helmets to prevent injuries.
Ÿ Be careful when moving the inverter with consideration of its
weight. Carry the equipment with your palms, rather than your
fingers. Be aware of personal injury caused by a falling inverter.
Ÿ When moving the inverter, avoid applying forces to DC switches,
PV terminals, BAT terminals, or AC terminals. The consequential
damage to terminals or switches will not be covered by any
warranty.
Ÿ When moving the inverter with a forklift, it is important to ensure
that the inverter is centered on the forks and is secured with
appropriate straps to prevent tip-overs.
NOTICE
1.1.3.2 Moving the MID inverter
Ÿ The MID inverter weighs about 30 kg and two persons are required
for moving it to the installation site.
Information
DANGER
WARNING
Information
WARNING
1.1.2 For electrical equipment
1.1.3.1 Moving heavy objects
＜18kg
（＜40 1bs）
18-32kg
（40-70 1bs）
32-55kg
（70-121 1bs）
＞55kg
（＞121 1bs）
Figure 1-1 Moving the inverter
Bekijk gratis de handleiding van Growatt MID 10-30KTL3-XH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Growatt |
| Model | MID 10-30KTL3-XH |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11746 MB |
