Greentec CAS 600 handleiding
Handleiding
Je bekijkt pagina 25 van 32
Usage
8
Manual CAS 600
EN
When the device is running, press the anion button in order to activate the anion
function. If you press the button again, the ionizer will be turned off.
Note: For this function, you may also use the ‘IONIZER’ button on the remote control.
Press this button to set the working time. Every push increases the working time by 60
minutes. You can set between 1 - 12 hours and the device is turned off when the timer
expires.
To exit this mode, press the button until you reach 12 hours and then press once more.
When the device is switched on, you may press the auto button in order to activate the
auto mode. In this mode, the motor speed will be adjusted automatically to the degree of
air pollution and the anion/ionizer function will be activated.
Note: If you change the wind speed during auto mode, the auto mode will be disabled.
speed level 1: PM2.5 = 0 - 70 | green display light
speed level 2: PM2.5 = 71 - 180 | blue display light
speed level 3: PM2.5 = 181 - 300 | yellow display light
speed level 4: PM2.5 = 601 - 999 | red display light
speed level 5: high speed mode for smoke purification
Press the sleep button to activate sleep mode. The lights will be turned off and the device
switches to the lowest speed level.
Press any button to wake the device up. Then press the sleep; speed –, speed + or auto
button in order to quit sleep mode.
If the timer was set before activating sleep mode, the machine continues working in sleep
mode until the timer runs out and then goes into standby.
Note: The machine also switches to sleep mode when the ambient light is at 10 lumens or
less for a duration of 3 minutes. Sleep mode is automatically disabled, when the ambient
light is at 11 lumens or more for 5 minutes.
Press this button to switch to a lower wind speed level. In total, there are 5 different
levels.
Note: If you use the speed- button, auto mode will be disabled.
Press this button to switch to a higher speed level. In total, there are 5 different levels.
Note: If you use the speed+ button, auto mode will be disabled.
Press this button to activate the high speed purification mode (wind speed level 5).
Press the speed –, speed + or auto button in order to quit high speed purification mode.
While the device is switched on, press this button in order to see the accumulated
working time on the display. Since the screen can only display three digits, the thousands
digit will be displayed first, then hundreds, tens and single. Please read them together.
If a filter replacement is necessary, this icon will light up. For more information, see
chapter Maintenance.
To connect the device to your app, see chapter Operation via app.
ANION
TIMER
AUTO
SLEEP
SPEED
WiFi
RESET
SPEED
HIGH SPEED SMOKE
PURIFICATION
Bekijk gratis de handleiding van Greentec CAS 600, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Greentec |
| Model | CAS 600 |
| Categorie | Luchtreiniger |
| Taal | Nederlands |
| Grootte | 7284 MB |
