GRE Wet Runner Plus RBR75 handleiding

102 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 7 van 102
EN
TROUBLE SHOOTING
If you have problems with your cleaner, follow the troubleshooting steps below to restore performance.
Note: turn off the power before making any repairs.
PROBLEM POSSIBLE CAUSES SOLUTION
The robots fails to suck
up debris.
The battery is low. Then charge the robot.
Impeller stuck.
Turn off the power supply of the robot and
visually check whether the impeller rotates.
If necessary, contact your dealer for further
instructions. Warning! Before servicing the
equipment, make sure that the robot is
turned off.
The impeller is damaged. Please contact your dealer for replacement.
The debris chamber is full. Clean the glove box and filter cover.
The robot stops moving
in the middle of the
pool (the rotating head
is still turning).
The robot was stopped by an
obstacle.
Check the cleaner for obstructions.
Remove obstacles.
The robot has been blocked by
the suction of the main pool
floor drain.
Turn off the filtration system (see
instructions in the manual).
The ground is not totally flat
It takes more minutes before moving again
or Make the bottom of the pool flat or trim
the bottom brush strip. Contact your dealer
for replacement parts.
The robot cannot cover
the entire pool or move
along the walls of the
pool.
The debris chamber is full. Clean the glove box and filter cover.
The operation time was shorter
than expected.
Clean the filter chamber and recharge the
robot for 4-5 hours
The water circulation generated
by the filtration system
interrupts the direction of
movement.
Turn off the filtration system (see
instructions in the manual).
The wheel is stuck. Check and remove debris from the wheels.
The robot moves slowly. The debris chamber is full. Clean the glove box and filter cover
The turning head does
not rotate or is clearly
rotating slowly.
The bottom of the swivel is
stuck.
The glove box is full, check and remove any
debris that may be stuck under the rotating
head. It can be rotated by hand and rinsed
with water until smooth.
The debris chamber is full. Clean the glove box and filter cover.

Bekijk gratis de handleiding van GRE Wet Runner Plus RBR75, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkGRE
ModelWet Runner Plus RBR75
CategorieStofzuiger
TaalNederlands
Grootte24546 MB