GRE Wet Runner Plus RBR75 handleiding
Handleiding
Je bekijkt pagina 6 van 102
EN
BATTERY ASSEMBLY AND REPLACEMENT
Do not treat electrical appliances as unclassified municipal waste. Use separate collection facilities. For
information on available collection systems, contact your local authorities.
Note: User must consult dealer before any
battery replacement.
Note: wrap the connector with
insulating tape immediately to avoid
a short circuit caused by two wire
terminals coming into contact with
each other.
· Do not remove the lithium battery without
authorization.
· When removing the lithium battery from the
vacuum device, please remove any rings, bracelets,
necklaces or watch that your are wearing.
· The short-circuit current generated by a battery
is enough to suck up rings (or similar items), which
can cause severe burns.
· Before removing the battery pack, please wear eye
protection, gloves and protective clothing.
· Be careful not to touch the wire or any metal parts,
as this can cause sparks or a short circuit.
· Do not smoke or light naked flames near the robot,
as this can set the battery on fire and give off gas.
· Avoid exposing the battery to fire or high
temperatures, as this could cause an explosion.
Note!
If the battery leaks, avoid contact with the damaged
battery and put it in a plastic bag.
If skin or clothing comes into contact with acid,
wash immediately with plenty of soap and water.
If the eyes come into contact with acid, rinse them
with water for at least 15 minutes and seek treatment
from a doctor.
Battery replacement:
1. Pull the four clips out of the core part of the
upper cover outwards, remove it from the body
assembly of the bottom cover and take out the
micro-particle filter.
2. Use a screwdriver to remove all screws on the
power cover of the bottom cover.
3. Open the battery cover, find the battery
connection line, press the clip on the connector,
pull it out and take out the battery.
4. Follow the steps for disassembly to re-install
the battery and assemble the charging
components. Note: (1) If there are impurities in
the seal ring, clean it and put it back into the seal
ring groove. (2) Make sure that the components
are reassembled in the right direction. The six
screw holes must be aligned to lock the screws.
Bekijk gratis de handleiding van GRE Wet Runner Plus RBR75, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GRE |
| Model | Wet Runner Plus RBR75 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 24546 MB |
