GRE RBR60 handleiding
Handleiding
Je bekijkt pagina 6 van 88
PROBLEM POSSIBLE CAUSES SOLUTION
Robots don’t capture debris.
The battery is low. Then charge the robot.
Impeller stuck.
Turn off the power supply of the
robot and visually check whether
the impeller rotates. If necessary,
contact your dealer for further
instructions. Warning! Before
servicing the equipment, make
sure that the robot is turned off.
Impeller damaged.
Please contact your dealer for
replacement.
The glove box is full.
Clean the glove box and filter
cover.
The robot stops moving in the
middle of the pool (the rotating
head is still turning).
The robot was stopped by an
obstacle.
Check the cleaner for obstructions.
Remove obstacles.
The robot is blocked by the
suction of the main pool floor
drain.
Turn off the filtration system (see
instructions in the manual).
The ground is not totally flat
It takes more minutes before
moving again or Make the
bottom of the pool flat or trim the
bottom brush strip. Contact your
dealer for replacement parts.
The robot cannot cover the entire
pool / move along the wall of the
pool.
The glove box is full.
Clean the glove box and filter
cover.
The operation time was shorter
than expected.
Clean the filter chamber and
recharge the robot for 4-5 hours
The water circulation generated
by the filtration system interrupts
the direction of movement.
Turn off the filtration system (see
instructions in the manual).
The wheel is stuck.
Check and remove debris from
the wheels.
The robot moves slowly. The glove box is full.
Clean the glove box and filter
cover.
The turning head does not rotate
or rotates obviously slowly.
The bottom of the swivel is stuck.
The glove box is full, check and
remove any debris that may be
stuck under the rotating head. It
can be rotated by hand and rinsed
with water until smooth.
The glove box is full.
Clean the glove box and filter
cover.
The debris escaped from the
robot.
The valve of the suction nozzle
(bottom of the cleaner) is broken.
The baffle at the suction cup
is like a door to prevent debris
from escaping from the debris
chamber. Contact your dealer
for replacement parts and
instructions.
Debris enters the outside of the
filter cover.
The filter cover is damaged.
Replace the filter cover with a new
one. Please contact your dealer for
replacement parts.
TROUBLE SHOOTING
If you have problems with your cleaner, follow the troubleshooting steps below to restore performance. Note:
turn off the power before making any repairs.
Bekijk gratis de handleiding van GRE RBR60, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GRE |
| Model | RBR60 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 10944 MB |
