Goodwe GW50K-SDT-C30 handleiding
Handleiding
Je bekijkt pagina 44 van 127
06 Electrical Connection
40
When all loads in the PV system cannot consume the generated electricity, the
surplus power will be fed into the grid. In this case, it is possible to monitor
the power generation with a Smart Meter or Smart DataLogger (Ezlogger
3000C) to control the amount of power fed into the grid.
6.5.2 Export Power Limit
WARNING
1. The place to snap t the CT shall be near the grid connection point and
the installation direction must be right. “-->” of CT refers that the inverter
current ows to the Grid. The inverter will be triggered with an alarm if CT
is installed reversely. It is unable to realize the power limit function.
2. The aperture of the CT should be larger than the outer diameter of the AC
power cable to ensure that the AC power line can pass through the CT.
3. For specic CT wirings, please refer to the documents provided by the
respective manufacturer, to ensure that the wiring direction is correct and
CT is able to work properly.
4. CT shall be snap tted on Cable L1, L2 and L3. Do not install it on Cable N.
5. Specication of CT:
• Choose nA/5A for the CT ratio. (nA: For primary current of the CT, n
ranges from 200 to 5000. Set the current value depending on the actual
needs. 5A: The output current of the secondary current of the CT.)
• The recommended precision of the CT: 0.5, 0.5s, 0.2, 0.2s. Ensure the
sampling error for the CT current shall be ≤ 1%.
6. To ensure the current detection accuracy of the CT, it is recommended
that the length of the CT cable should not exceed 30 m.
7. The inverter supports setting parameters through WiFi, Bluetooth signal
near-end, connecting to cell phone or WEB interface to set the device-
related parameters, check the device operation information, error
information, and timely understand the system status.
• The 4G Kit-CN-G20, 4G Kit-CN-G21, Wi-Fi Kit, Wi-Fi/LAN Kit, WiFi Kit-20,
or WiFi/LAN Kit-20 Smart Dongle can be used when there is only one
inverter in the system.
• When the system contains multiple inverters parallel connection, the
main inverter needs to be installed with the Ezlink3000 Smart Dongle.
Bekijk gratis de handleiding van Goodwe GW50K-SDT-C30, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Goodwe |
| Model | GW50K-SDT-C30 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11037 MB |
