GLP WildBar 16 handleiding
Handleiding
Je bekijkt pagina 11 van 23
German Light Products® Wild Bar 16
Rev. 20250228-01 11
Pattern transition
The Pattern Transition channel lets you choose how Pattern A should change into
Pattern B. This change can be a snap, a soft crossfade, a Fade Over Blackout (FOB) or
Fade Over Full (FOF).
Special/Control DMX channel
The Special/Control DMX channel lets you change fixture settings and perform a fixture
reset from the control desk (a possibility that can be very useful during a show or for a
specific scene). To apply a command on the Special/Control channel, you must hold the
command for the time indicated in the DMX channel index section at the end of this
user manual.
To trigger a reset using the Special/Control channel, you must send the DMX value for
this function for 3 seconds. If you want to trigger an additional reset using the
Special/Control channel, you must first move away from the Reset DMX value and then
return to this value. This requirement to change DMX values eliminates the risk of the
fixture entering an unwanted Reset loop if it is patched wrongly.
Note: Most of the fixture settings available in the fixture’s control menus or on the
Special/Control DMX channel are also available via RDM.
Fan modes
Lets you give priority to lowest fan noise or most powerful cooling. In all modes, if the
fixture gets too hot, light intensity will be reduced to control temperature. Light output
will be shut down if a dangerous temperature is reached.
Regulated mode gives priority to light output and only operates fans as necessary.
High mode sets the fixture to give maximum light output and suits operation in
high ambient temperatures. Fans are set to constant operation at high speed.
Medium mode sets fans to constant operation at medium speed. Light output
intensity is slightly reduced.
Low mode sets fans to constant operation at low speed and is optimized for
minimum noise. Light output intensity is reduced.
Off sets the fixture to disable all fans which are not essential to cool important
components. Essential fans will rotate as slowly as possible to reduce the noise level
to a minimum. Light output intensity is reduced.
PWM frequency
You can select different LED PWM frequencies to avoid flicker on cameras. Higher PWM
frequencies reduce the dimming resolution.
No signal
Sets how the fixture behaves when no DMX signal is present:
Blackout sets the fixture to black out whenever it is not receiving a DMX signal.
Hold sets the fixture to continue using the last DMX values it received.
Bekijk gratis de handleiding van GLP WildBar 16, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | WildBar 16 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 2741 MB |
