GLP MAD MAXX handleiding
Handleiding
Je bekijkt pagina 7 van 32
German Light Products GLP MAD MAXX
Rev. 20250625-1 7
overheating. Do not reapply power until the fixture has been repaired and made
safe by a technician authorized by GLP.
● Check that all power distribution equipment, cables and connectors are rated
IP65 minimum, in perfect condition, rated for the electrical requirements of all
connected devices, suitable for their application and suitable for the installation
environment.
● To ensure IP65 protection, use only a power cable with a Neutrik PowerCON True1
connector and data cables with IP65-rated Neutrik XLR or EtherCON connectors.
If a cable connector is not in perfect condition, install a new connector on the
cable following the connector manufacturer’s instructions. Send old connectors
for recycling.
● The fixture’s connectors are equipped with tethered rubber seals. Apply the
rubber seal to every connector that does not have a plug inserted in it so that the
connectors are protected from water and moisture.
● Use a power cable that is minimum 14 AWG or 1.5 mm
2
, minimum 16 A-rated and
temperature-rated to suit the application. In the USA and Canada the cables must
be UL-listed, type SJTW or equivalent. In the EU the cables must be type H05RN-F
or equivalent, or for outdoors applications cables must be type H07RN-F or
equivalent.
● Make sure that cables open into dry areas or sealed junction boxes. Moisture can
be drawn along cables by capillary action or pressure variations resulting from
thermal expansion.
● Arrange cables so that they arrive
at connectors from below. Make
sure that it is impossible for water
to flow down cables and
accumulate at connectors. If
necessary, provide extra cable
slack and create ‘drip loops’
before connectors.
● See the ‘Fixture overview’ section later in this Safety Manual for the location of the
main fuse. Disconnect the fixture from power before attempting to replace the
fuse. Replace the fuse in dry conditions only. Replace fuses with ones of the same
type and rating only. If you have any questions about fuse replacement, please
contact GLP Service.
● Some internal components carry a high voltage while the device is connected to
AC mains power. Some of these components can remain live for up to 30 minutes
after the power supply has been disconnected.
Bekijk gratis de handleiding van GLP MAD MAXX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | MAD MAXX |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4369 MB |
