GLP MAD MAXX handleiding
Handleiding
Je bekijkt pagina 17 van 32
German Light Products GLP MAD MAXX
Rev. 20250625-1 17
5. Preparation for use
Warning! Read ‘Safety’ starting on page 5 and read ‘Transport and storage’
on page 12 before installing the GLP MAD MAXX.
Important! Set the pan and tilt locks to OFF before putting the fixture in
its flightcase and before applying power to the fixture.
Pan and tilt locks
See drawing on right. The fixture has a tilt lock A and
pan lock B that lock the position of the head and
yoke. Set both locks to ON before lifting the fixture
and for convenience when servicing the fixture. Set
both locks to OFF before transporting the fixture in
its flightcase and before applying power to the
fixture.
Preparing to install the fixture
Warning! The four pillars at the corners of the base
are provided only for guiding a fixture when the
weight of the fixture is supported. Do not use the
pillars to support the weight of the fixture.
To remove the fixture from a flightcase and prepare for installation on a truss or
similar structure:
1. See Figure 2. Obtain
one or two GLP Truss
Mount Bars C for the
MAD MAXX. You can
suspend the fixture
from one or two bars
installed as shown. If
you use one single bar,
it must be installed
along the center axis as
shown in Figure 2.
2. Bolt two rigging
clamps D to each Truss
Mount Bar C using
suitably dimensioned
bolts, grade 8.8 steel,
and self-locking nuts.
Use only rigging
clamps (half-coupler, G-
clamps or quick-trigger
clamps) that are
approved to hold the
weight of the fixture.
A
B
D
D
D
D
C
C
Figure 2. Rigging the fixture
Installation with two
Truss Mount Bars
Installation with one
Truss Mount Bar
Bekijk gratis de handleiding van GLP MAD MAXX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | MAD MAXX |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4369 MB |
