GLP JDC1 handleiding
Handleiding
Je bekijkt pagina 12 van 76
www.glp.de
12 JDC1 User Manual Rev. 20240830-01
4. Features
The impression JDC1 from GLP represents a whole new class of moving head
combined strobe/color effect lighting fixture. It delivers unprecedented levels of bright,
cool white light output combined with a full-face color wash panel that uses 1320 high-
quality RGB LEDs. The strobe tube and the color panel can each be split into 12
segments with individual control, and the whole array can be fully pixel mapped
through any standard controller. Strobe and color effects can be controlled
separately, but they can also be combined for stunning strobe, blinder and wash
effects. The JDC1 also features a fast-action moving head with 16-bit control and a
185° tilt range.
The JDC1 is designed for permanent or temporary indoor use. It can be used outdoors
if it is protected from moisture and precautions are taken to prevent damage from
direct sunlight. It may be placed upright on a level surface or suspended from a
suitable structure as described this manual.
The JDC1 is not suitable for household use, for use in any location where unattended
children have access to it, or for use in permanent outdoor installations.
Beam
The JDC1 features a traditional central single-tube element, the Beam, containing 216
cool white LEDs that produce powerful white light.
You can run powerful shutter effects (including a strobe at up to 16.67 Hz) and
dynamic FX patterns on the Beam, or you can operate it continuously to give high-
output blinder and wash effects with an 86° beam angle. If you set an intensity on the
Beam, it will be used as the background intensity if you run a shutter effect or FX
pattern on the Beam.
You can control the Beam as one unit or divide it into 12 segments that you can use as
separately controllable pixels.
Color Plates
The JDC1 has two RGB color panels – the Plates – on either side of the central Beam
tube. Each Plate contains 660 RGB LEDs.
You can run a wide range of color effects including shutter / strobe effects and
dynamic FX patterns on the Plates, or you can operate them continuously using RGB
color mixing to provide a wide (148°) color wash. If you set a color mix on the Plates, it
will be used as the background color if you run a shutter effect or FX pattern on the
Plates.
You can control the Plates as one unit or divide them into 12 segments that you can
use as separately controllable pixels.
DMX control modes
Six DMX control modes are available in the JDC1. All modes offer the same functions
on DMX channels 1-7. DMX Mode 1 offers standard functions on channels 1-14, DMX
Modes 2-5 offer additional functions using additional DMX channels, while DMX Mode
6 (introduced in software version 1.78) has no Plate shutter effects but offers grouped
RBGW control of the Plates. Mode 6 uses only 11 channels.
Bekijk gratis de handleiding van GLP JDC1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | JDC1 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 9927 MB |
