GLP impression X5 IP handleiding
Handleiding
Je bekijkt pagina 20 van 41
www.glp.de X5 IP
20 impression X5 IP User Manual
● Independent – In this mode, the Sub module channel group can be controlled
independently of the Main module channel group and acts as an independent
fixture.
Note that no matter which Sub module mode setting you select, the following
applies:
● The Mix Priority channel is always active and will affect how the two dependent
or independent modules are mixed.
● Some of the general color management channels of the Main module such as
CTC, CQC, M/G-Shift and Tungsten simulation will always affect the Sub module.
Performance modes
You can select between three different settings for the movement speed of the
fixture’s mechanical effects (pan/tilt and zoom):
● Normal sets mechanical effects movement to give an optimum balance
between speed, quietness and smoothness. Normal is the default setting.
● Fast sets movement to maximum speed. This setting gives very fast effect
movement but can result in higher noise levels.
● Smooth optimizes the smoothness of the mechanical effects and gives lowest-
noise performance. This setting gives extremely low noise and smooth
performance, but effect movement will be slower than in Normal mode.
PWM frequency
This setting lets you select between different PWM frequencies for different
applications and adjust LED frequencies to give the best results at different camera
shutter frequencies. Changing the PWM frequency can improve dimming
performance or help avoid flicker and beat frequencies in video images.
The following PWM settings are available:
● Low – PWM frequency is fixed at a lower level, giving best dimming results.
● Optimum (default) – PWM frequency is set to a level which offers a good
compromise between best dimming results and avoiding flicker.
● High1 – PWM frequency is set to a higher level.
● High2 – PWM frequency is set to highest level.
Note: A higher PWM frequency may affect dimming performance. The PWM
frequency setting is stored in the fixture and is not affected by cycling power off
and on. However, it will be affected if you use the Factory Defaults command in the
control menus. As a rule, you should set all the fixtures in an installation to the
same PWM frequency in order to ensure the same performance.
Bekijk gratis de handleiding van GLP impression X5 IP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | impression X5 IP |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4489 MB |
