GLP Impression X5 Compact handleiding
Handleiding
Je bekijkt pagina 26 van 83
www.glp.de X5 Compact
26 Rev. 20230928-01
● Save Settings: Lets you save the current fixture settings to one of the three user
settings presets. You can load a user settings preset that you have saved with a
Load User Settings command (see Fixture Settings → Load User Settings). The default
fixture preset cannot be changed.
This command only saves fixture settings (Fan Mode, Color Mix etc.). It does not
save fixture configuration information such as DMX address and DMX mode.
● Firmware Push (Fixture2Fixture): Pushes the fixture’s firmware (flash storage) to all
other fixtures of the same type via the DMX link.
Important! The impression X5 series firmware is fully compatible with all X5 series
fixtures. This means that a firmware push carried out by an X5 will also push its
firmware to other X5 fixtures such as X5 Compact, X5 Bar 1000 and X5 IP Bar 1000
etc.
Load Factory Defaults
Reloads all factory defaults over the entire fixture and brings the fixture into standard
show condition.
You must confirm the function for 3 seconds before the default settings are loaded.
Important! The factory default settings that are reloaded with this command include all
data and network configuration parameters such as DMX start address, IP
configuration etc. You may therefore lose communication with your controller.
The Load Factory Defaults command does not affect device counters and calibration.
Factory Menu
Important! Do not enter the Factory Menu unless you are a trained service professional
with service documentation or clear instructions from GLP Service. Read the user and
service documentation carefully before entering this menu. In the Factory Menu you
can apply critical settings which can damage the fixture.
The Factory Menu is a hidden menu for the manufacturer or professional service
technicians only. This special menu allows fixture calibration and the adjustment of all
mechanical features following the manufacturer’s instructions.
To enable the Factory Menu, apply power to the fixture and press the ENTER and BACK
buttons together while the pre-boot screen is being displayed. You can release the
buttons as soon as FACTORY MODE appears in the black display. After doing this,
Factory Menu is visible as the last item in the main menu. The Factory Menu will remain
available until the next power cycle. While the Factory Menu is enabled, all display
timeouts are disabled to make working on the fixture easier. A ‘Factory’ symbol is also
visible in the main screen.
Bekijk gratis de handleiding van GLP Impression X5 Compact, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | Impression X5 Compact |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 13142 MB |
