GLP impression S350 handleiding
Handleiding
Je bekijkt pagina 18 van 48
www.glp.de
18 GLP impression S350 User Manual Rev. C
Effect wheel shortcuts
By default, the color wheel and gobo wheels take the shortest, fastest route from one
slot to the next, even if this means that they may pass through the open position. To
avoid the wheels passing through the open position when they change from one slot
to the next you can set Effect shortcuts on the Special/Control DMX channel or in the
control panel to OFF.
Behavior when the fixture is not receiving a DMX signal
You can set the fixture to react in four different ways if no DMX signal is present (if the
fixture is being controlled by DMX but the DMX signal stops, or if you apply power to
the fixture when no DMX signal is present):
• Hold sets the fixture to continue obeying the last DMX values it received. This is the
default setting.
• Blackout sets the fixture to black out whenever it is not receiving a DMX signal.
• Stand-Alone sets the fixture to play its stored stand-alone scene (see DMX Shot below)
when the fixture is not receiving a DMX signal. If no stand-alone scene is stored in
memory, the fixture will black out.
• DMX Shot takes a snapshot of the DMX values that are currently being received and
stores them in the fixture’s memory as its stand-alone scene. The fixture will display this
stand-alone scene if it is set to Stand-Alone (see above) and is not receiving a DMX
signal.
You can select one of the four settings above using either the control panel or the
Special/Control DMX channel.
Stand-Alone operation
If the fixture is set to Stand-Alone and if a stand-alone scene has been stored in its
memory using the DMX Shot command, it will display its stand-alone scene at all times
when it is powered on but not receiving a DMX signal. You can therefore use this
setting if you want fixtures to automatically start stand-alone operation when you
apply power to them.
PWM frequency
You can change the LED dimming PWM frequency in order to avoid flicker and beat
frequencies in video images. To do this, select a new PWM frequency using either the
Settings DMX channel or the fixture’s control panel.
The default PWM setting is 3000 Hz. You can set the PWM frequency to 2200 Hz,
3000 Hz, 4800 Hz, 9600 Hz or 25 kHz. Note that a higher PWM frequency may affect
dimming performance.
The PWM frequency setting is stored in the fixture and is not affected by cycling power
off and on. However, it will be affected if you use the Factory default command in the
control menus.
As a rule, you should set all the fixtures in an installation to the same PWM frequency in
order to ensure the same performance.
Bekijk gratis de handleiding van GLP impression S350, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | impression S350 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 5493 MB |
