GLP impression FR1 handleiding
Handleiding
Je bekijkt pagina 5 van 36
German Light Products®
Impression® FR1 User Manual 5
If you have questions about the safe operation of the impression FR1, please contact
an authorized GLP distributor (see list of distributors at www.glp.de).
Use the product only as directed in this user manual. Observe all markings in this user
manual and on the product.
Refer any service operation not described in this manual and refer all repairs to a
technician authorized by GLP.
The light source in this product must not be changed by the end user.
Read and follow the user documentation for all additional equipment.
Electrical safety
Do not allow the product to come into contact with water or moisture.
Use only a source of AC mains power that complies with local building and electrical
codes and has both overload and ground fault (earth fault) protection.
Ensure that the product is electrically connected to ground (earth).
Disconnect the product from AC mains power before carrying out any installation or
maintenance work and when the product is not in use.
Neutrik powerCON connectors are not suitable for hot-plugging, so ensure that the
power outlets or power switches on the circuits used to supply the product with power
are located near the product and are easily accessible so that the product can
easily be disconnected from power.
Disconnect the product from power immediately if the power plug or any seal, cover,
cable, or other component is damaged, defective, deformed, wet or showing signs
of overheating. Do not reapply power until the product has been repaired and made
safe by a technician authorized by GLP.
Before using the product, check that all power distribution equipment and cables are
in perfect condition and rated for the electrical requirements of all connected
devices.
Use only Neutrik powerCON cable connectors for input and throughput at the
product’s power connectors.
Use minimum 14 AWG or 1.5 mm
2
power input and relay cables that are minimum
16 A rated and temperature-rated to suit the application. In the USA and Canada the
cables must be UL-listed, type SJT or equivalent. In the EU the cables must be type
H05VV-F or equivalent.
Do not connect devices to power in a chain using their power throughput connectors
if the total maximum current draw of all the devices in the chain when added
together will exceed the current rating of any cable or connector used at any point
in the chain. The supplied power input cable is rated as follows:
- US power cable: 16 A, 14 AWG, UL listed, E304117, SJT, 4.9 ft.
Bekijk gratis de handleiding van GLP impression FR1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | impression FR1 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4168 MB |
