GLP impression FR1 handleiding
Handleiding
Je bekijkt pagina 15 van 36
German Light Products®
Impression® FR1 User Manual 15
5. Preparation for use
Warning! Read ‘Safety’ starting on page 4 for important safety information
that you must understand before you install or operate the fixture.
Included Items
The impression FR1 is supplied with a power cord with powerCON connector and an
M10 x 11 countersunk bolt for fastening a half-coupler clamp to the base of the fixture.
Orientation and location
The impression FR1 may be rigged in any orientation or placed on a level surface.
Keep the head at least 0.5 m (20 in.) away from combustible materials (including
curtains and stage scenery) when the fixture is installed.
Make sure that there is no risk of collision when the head pans and tilts. Allow a
minimum center-to-center distance of 360 mm / 14.2 in. between impression FR1
fixtures.
Mounting on a rigging truss
To mount the impression FR1 on a rigging truss or similar
support in any orientation:
Pass an M10 steel bolt or screw through a half-coupler
type rigging clamp. See Figure 4. Check that the bolt will
protrude minimum 9 mm / 0.35 in. and maximum 11 mm /
0.43 in. into the base of the fixture when tightened.
Figure 5. Mounting points in base
B
S
n
a
p
A
S
n
a
p
B
S
n
a
p
Figure 4. Bolt protrusion
Bekijk gratis de handleiding van GLP impression FR1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | impression FR1 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4168 MB |
