GLP DoP Converter DINrail handleiding
Handleiding
Je bekijkt pagina 22 van 32
www.glp.de DoP Converter DINrail / UM
22 GLP DoP Converter User Manual Rev. 20220320-01
Setting the DoP channel
The GLP DoP Converter can transmit or receive a GLP DoP signal on one of ten
different DoP channels via the same mains power line. This means that up to ten DMX
universes in total can be transmitted over the same power line.
To set the DoP channel that the Converter uses:
1. Press and hold control button B for 1-3 seconds. The current DoP channel will
appear in the center of the LCD display. The default DoP channel is Channel 01.
2. Press and hold control button A for 1-3 seconds to increase the DoP channel
number by one (from 01 to 02, for example). Each short press on control button A
increases the channel number by one. After DoP channel 10 the number begins
again at DoP channel 01.
DoP in GLP fixtures
GLP’s proprietary DoP technology is already implemented in some GLP fixtures. You
can control these fixtures directly using the DoP signal on the power line that the fixture
is connected to.
Since a GLP DoP Converter in transmitter mode can transmit on up to ten different DoP
channels (i.e. up to ten different DMX universes), you must set up the DoP-compatible
fixture to use the correct DoP channel. You can set the fixture’s DoP channel using
either a coding switch or the fixture’s integrated control panel.
If the DoP channels are correctly set on the GLP DoP Converter in transmitter (TX)
mode and the GLP DoP fixture, you can control the fixture with the DMX signal that you
send to the DoP Converter. The DoP Converter sends the DMX signal as a DoP signal
over the power line, the fixture receives the DoP signal, and then the fixture internally
converts it back into the original DMX data to control the fixture.
A GLP fixture with an integrated DoP module will always receive all 512 DMX channels.
There is no limitation on the number of channels that the fixture will receive.
RX start address
When the DoP is in receiver mode (RX), the RX start address is the first DMX channel
that the DoP retrieves from the power line and demodulates. Starting from this
channel, the DoP demodulates the number of DMX channels that are available in its
version.
For example:
1. A DoP Converter RX024 version that is set up with RX start address 001 will retrieve
the data on DMX channels 01 to 24 from the DoP power line and send that data
out as DMX channels 01 to 24 at its DMX output.
The display will show RX024/001, indicating:
- Receiver mode
- 24-channel version
- starting demodulation from DMX channel 001.
Bekijk gratis de handleiding van GLP DoP Converter DINrail, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GLP |
| Model | DoP Converter DINrail |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3150 MB |