Globe GVP20A handleiding
Handleiding
Je bekijkt pagina 10 van 20
Page 10
Operating Instructions
TO AVOID SERIOUS PERSONAL INJURY:
• NEVER touch vacuum packaging machine without training and authorization from your supervisor or if
you are under 18 years old. Read the instruction manual rst.
• ONLY use the vacuum packaging machine in a clean, well-lighted work area away from children and
visitors.
• NEVER put hands or ngers into the vacuum packaging machine during operation.
• BEFORE CLEANING, SERVICING, OR REMOVING ANY PARTS, always turn vacuum packaging
machine OFF and unplug unit.
• KEEP unit UNPLUGGED when not in use to prevent accidental start up.
VACUUM PACKAGING MACHINE OPERATION (MODELS GVP6 AND GVP20)
• Do not operate vacuum packaging machine without rst
checking/installing oil into the motor/pump. Damage to vacuum
packaging machine will occur.
• Activate the pump cleaning every 2000 cycles or monthly to
prevent damage to the motor/pump. Refer to the Cleaning Section
for instructions on how to activate the pump.
1. Place one or two of the ller plates in the vacuum packaging machine in order
to level the product with the height of the sealing bar (Figure 10-2).
Note: Filler plates can be used to reduce the required vacuum time.
Filler plates take up space, leaving less air to be removed from
the vacuum chamber.
2. Place the vacuum sealing bag (or bags) with the product, inside the vacuum
chamber.
3. Position the vacuum sealing bag with the opening at on the sealing bar
(Figure 10-3).
Note: Any excess top portion of the vacuum sealing bag should be
placed between the vacuum chamber wall and the seal bar.
Excess top portion should not exceed 2 cm over the vacuum
sealing bag.
Note: Make sure to place any vacuum sealing bag that contains liquids
or wet product below the height of the seal bar.
4. Turn on the ON/OFF switch. ON/OFF switch light will illuminate. Display will
show current vacuum mode setting (Figure 10-4).
Note: The quality of the vacuum can be veried by checking the
tightness of the pouch and the product. Check for air pockets or
air leaks. If product is not vacuum packaged tightly, increase the
vacuum time by 5 seconds, vacuum and seal again.
5. Select the required vacuum time by pressing the VACUUM ‘’up’’ or ‘’down’’
arrows on the control panel.
Figure 10-4
Figure 10-2
Figure 10-3
Bekijk gratis de handleiding van Globe GVP20A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Globe |
| Model | GVP20A |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3546 MB |
