Handleiding
Je bekijkt pagina 9 van 42
16
17
MAINTENANCE AND CLEANING
MAINTENANCE AND CLEANING MAINTENANCE AND CLEANING
Cleaning of door tray
According to the direction arrow in the figure
below, use both hands to squeeze the tray, and
push it upward, then you can take it out.
After washing the tray having been taken out, you
can adjust its installing height in accordance with
your requirement.
Cleaning of glass shelf
As the innermost part of the refrigerator liner
where contacting the shelves has a backstop, you
shall raise the shelves upward, then you can be
able to take it out.
Adjust or clean the shelves according to your
requirement.
Cleaning the vegetable drawer
1. Remove the contents of the drawer. Hold the
handle of the vegetable drawer and pull it out
completely until it stops.
2. Lift the vegetable drawer up and remove it by
pulling it out.
ATTENTION
The appliance shall run continuously once it is
started. Generally, the operation of the appliance
shall not be interrupted;otherwise the service life
may be impaired
Disconnect the appliance from the electrical supply
before ndertaking any routine maintenance. Allow
at least 5 minutes before restarting the appliance, as
frequent starting may damage the compressor.
Do not use mechanical devices or other means to
accelerate the defrosting process, other than those
recommended by the manufacturer.
Do not try to repair, disassemble or modify the
appliance by yourself. In case of repair please contact
our customer service.
Eliminate the dust on the back of the unit at least once
in the year to avoid hazard by fire, as well as increased
energy consumption.
Check the door gasket regularly to make sure there
are no debris. Clean the door gasket with a soft cloth
dampened with soapy water or diluted detergent.
The interior of the product should be cleaned regularly
to avoid odor.
Use a soft cloth or sponge to clean the inside of the
product, with two tablespoons of baking soda and a
quart of warm water. Then rinse with water and wipe
clean. After cleaning, open the door and let it dry
naturally before turning on the power.
For areas that are difficult to clean in the product
(such as narrow sandwiches, gaps or corners), it is
recommended to wipe them regularly with a soft rag,
soft brush, etc. and when necessary, combined with
some auxiliary tools (such as thin sticks) to ensure
no contaminants or bacterials accumulation in these
areas.
Wipe the outer surface of the product with a soft cloth
dampened with soapy water, detergent, etc., and then
wipe dry.
Do not use hard brushes, clean steel balls, wire brushes,
abrasives (such as toothpastes), organic solvents (such
as alcohol, acetone, banana oil, etc.), boiling water,
acid or alkaline items, which may damage the fridge
surface and interior. Boiling water and organic solvents
such as benzene may deform or damage plastic parts.
Do not rinse directly with water or other liquids during
cleaning to avoid short circuits or affect electrical
insulation after immersion.
Defrosting
While the refrigerating unit is running, beads of
condensation or hoarfrost from at the back of the
refrigerator compartment. This is normal. It is not
necessary to wipe off the condensation or frost. The
rear panel defrosts automatically. The condensation
runs into the condensation channel and is conveyed
to the refrigerating unit where it evaporates.
Note: Keep the condensation channel and drainage
hole clean, so that the condensation can run out.
CAUTION
Bekijk gratis de handleiding van Glem Gas GRT110WH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Glem Gas |
| Model | GRT110WH |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 5082 MB |
