Gladiator GANA201BMS handleiding
Handleiding
Je bekijkt pagina 4 van 16
4
3. Hang the wall cabinet onto the GearTrack
®
channel.
6"
The GearTrack
®
channels should
be installed with
the spacing as
shown.
Wall
Tighten the M6 x 16 hex
socket head screws from the
inside of the wall cabinet
■ Make sure the bracket is fully engaged in the wall slots as
shown. Tighten the pre-attached M6 x 16 hex socket head
screws fully into the bracket and make sure they go into the
wall slots.
NOTE: If installing the wall cabinet on GearTrack
®
channels,
a second channel must be installed 6"(15.24cm) below the
bottom of the supporting channel so the cabinet will hang
level.
NOTE: For installation of the Gladiator
®
GearTrack
®
channels,
please refer to the manual instructions included with the
Gladiator
®
GearTrack
®
channels.
Install the 24"Flex 2-door Base
Cabinet
NOTE: Flex Brackets are sold individually and Gladiator
®
GearTrack
®
channels are sold separately.
1. Install the brackets (P1) to the cabinet.
P1
X
2
F5
X 8
F3
X
8
P1
F5
F3
Two brackets
required as
shown
bracket's
orientation
during assembly
P1: Bracket (2) F1: M6 round head square
neck bolts (8)
F2: M6 hex ange nuts (8)
■ Temporarily turn the base cabinet upside down as shown.
■ Attach the brackets to the back of the base cabinet as
shown with eight M6 round head square neck bolts (F5) and
eight M6 ange nuts (F3).
ASSEMBLY INSTRUCTIONS
Bekijk gratis de handleiding van Gladiator GANA201BMS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Gladiator |
| Model | GANA201BMS |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2666 MB |
