Girmi AP45 handleiding
Handleiding
Je bekijkt pagina 14 van 24
13
OPERATING
Push the ON/OFF button (3) to switch on or off the unit.
Vacuum cleaner
Warning: This product is not suitable for suction of sharp or pointed objects, flammable, explosive or
hazardous to health, acids, combustible objects such as cigarettes, burning embers, matches or ashes.
This vacuum cleaner includes two filters, which must be mounted properly.
- Sponge filter (10): for vacuuming on wet surfaces. For each use, make sure that the filter is mounted
correctly, and that covers the entire surface of the cone.
- Main filter (4) for dry vacuuming. For each use, make sure that the filter is mounted correctly.
Air blowing mode
On the back of motor unit (2) there is the air outlet. Simply get stuck on the hose to use the product as a
blower, to move dirt from corners otherwise not accessible.
Setting the airflow
There is an opening on the handle of the flexible hose (12) which controls the airflow volume (see figure).
Open or close the opening to set the desired suction power.
ACCESSORIES
Wet&Dry brush: use for vacuum cleaning on wet and dry floors and carpets as well
Nozzle: for corners, baseboards, small spaces, etc. ...
Mini-brush: for cleaning libraries, windows and vacuum crumbs.
MOTOR PROTECTION DEVICE
The motor is protected by a device, which comes into action when the water level inside the tank (6) is too
high; or if the motor is overloaded due to a filling of the air flow (dirty filter, accessories blocked by an
object, overflow).
The activation of the protection device causes a very loud noise. In this case, IMMEDIATELY turn off the
power, unplug the unit and check the reason why the protective device has started:
- If the container is full, empty the container.
- If the filter is very dirty, clean it.
- If something blocks the attachment, remove the obstacle
MAINTENANCE AND CLEANING
MAINTENANCE
The filters should be cleaned periodically. In addition, the filtering efficiency can run out over time. It is
advisable to replace the filter after 50 hours of use approx. Do not operate without filter. When one of the
filters runs out or breaks, it must be replaced.
Always ask for original spare parts; the filters kit is model “Girmi AP46”.
MAIN FILTER (44) CLEANING
When the main filter is dirty it should be washed to ensure good performances.
- Extract the filter (4) from the container (6) and open the end by removing the white tab.
- Empty the cloth filter into a waste bin.
- For more thorough cleaning, turn the bag inside out and slam or blow the inside.
- Turn the bag inside out again, close with the white tab and reassemble the filter (4)
SPONGE FILTER (10) CLEANING
The sponge filter should be cleaned periodically. Remove it from the lid and rinse it in warm water for
removing the dirt. At least partially dry it before assembling.
INNER TANK (6) CLEANING
Unhook the body and remove the dust bag, if it is mounted. It is recommended to empty the trash container
before reaching the maximum capacity, as to prevent the engine from overheating. In any case, empty the
tank when you hear a change in the sound emitted by the device.
After having drained, directly rinse it with water to complete cleaning.
Bekijk gratis de handleiding van Girmi AP45, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Girmi |
| Model | AP45 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 2698 MB |
