GeoVision GV-GVS2100 handleiding
Handleiding
Je bekijkt pagina 36 van 85
32
2. Click “Enable” and set the alarm holding time.
3. Trigger alarm out. When the device is disconnected, the system will trigger the alarm out.
5.3.3 Alarm In
This function is only available for some models. To set sensor alarm (alarm in):
Go to Config→Alarm→Alarm In interface as shown below.
1. Click “Enable” and set the alarm type, alarm holding time and sensor name.
2. Set alarm trigger options. The setup steps are the same as motion detection. Please refer
to 5.3.1 Motion Detection for details.
3. Click “Save” button to save the settings.
4. Set the schedule of the sensor alarm. The setup steps of the schedule are the same as the
schedule recording setup. (See Schedule Recording Settings).
Select the sensor ID and click “Apply settings to” to quickly apply the settings to the other
alarm input.
Bekijk gratis de handleiding van GeoVision GV-GVS2100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GeoVision |
| Model | GV-GVS2100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 14248 MB |
