GeoVision GV-GVS2100 handleiding
Handleiding
Je bekijkt pagina 35 van 85
31
⚫ SD Card Error
When there are some errors in writing SD card, the corresponding alarms will be triggered.
1. Go to Config→Alarm→Exception Alarm→SD Card Error as shown below.
2. Click “Enable”.
3. Set the alarm holding time and alarm trigger options. Trigger alarm out, Email and FTP.
The setup steps are the same as motion detection. Please refer to 5.3.1 Motion Detection
for details.
⚫ IP Address Collision
1. Go to Config→Alarm→Exception Alarm→IP Address Collision as shown below.
2. Click “Enable” and set the alarm holding time.
3. Trigger alarm out. When the IP address of the device is in conflict with the IP address of
other devices, the system will trigger the alarm out.
⚫ Cable Disconnection
1. Go to Config→Alarm→Exception Alarm→Cable Disconnected as shown below.
Bekijk gratis de handleiding van GeoVision GV-GVS2100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GeoVision |
| Model | GV-GVS2100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 14248 MB |
